498241
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Cable connection
• Connect INPUT of the amplifier to the head unit line output with good quality RCA cables.
By connecting the RCA jacks OUTPUT with a additional amplifier, a full range signal will be
provided to the amplifier.
• Connect the subwoofer with the terminal block (SPEAKER OUTPUT + BRIDGED -) of the
amplifier.
• The minimum final subwoofer impedance must not be below 4 Ohm per channel pair. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
X-OVER - Switch & Control
• For the operation with one subwoofer select at X-OVER "LP/BP" (LOW PASS/BANDPASS).
Adjust a frequency between 30Hz - 150Hz, depending on the size and response of the Subwoofer.
The Lowpass adjustment can be done with the LOW PASS control.
• The HIGH PASS - Control is working in this configuration as controller to adjust the Subsonic-Frequency (lower Frequency Cut-off).
Therewith a BANDPASS-Signal will be generated, where too low and not hearable frequencies will be eliminated.
Thereby a clean and powerful Bass-Signal will be generated. The adjustable level depends on the size and response of the
subwoofer and should be between 10Hz (no cut-off) and 30Hz (max. suggested Level).
NOTE: If the HIGH PASS - Level is higher than the LOW PASS - Level, no Sound is hearable.
LEVEL INPUT - Control
• Turn the LEVEL INPUT - Control on the amplifier to "4V" position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the LEVEL INPUT - Control clockwise until you hear some distortion.
• Then turn back the LEVEL INPUT - Control slightly until you can hear clean sound.
BASS BOOST - Control
• The BASS BOOST - Control adjusts the bass level at 45 Hz from 0 up to 12dB. Please use the Bass-Boost carefully.
BASS REMOTE
• The BASS REMOTE allows to control the Bass-Level for example from the driver's seat.
1-Channel-Mode: 1 Subwoofer / Mono bridged
Caution
Please avoid to connect speaker (-) to the ground or vehicle chassis.
Connect RCA cable
from head-unit with
RCA input (INPUT).
Subwoofer
4 - 8 Ohm
FUS E
BRIDGED
SPEAKER OUTPUT
GND REM 12V
POWER INPUT
L R
OUTPUT OUTPUT
LL
RR
INPUT INPUT
LL
RR
POWERPOWER
PROTECTPROTECT
BASS REMOTEBASS REMOTE
HPHP
LP/BPLP/BP
FULLFULL
X-OVERX-OVER
BPFBPF
4V4V
30Hz30Hz
150Hz150Hz
0dB0dB 12dB12dB
BASS B OOSTBASS B OOST
0.2V0.2V
1.2kHz1.2kHz
10Hz10Hz
HIGH P ASSHIGH P ASSLOW P ASSLOW P ASS
LEVEL I NPUTLEVEL I NPUT
BASS REMOTE
2 Channel Amplifier - Speaker- & RCA-Connection
GTR420.2 – GTR620.2
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crunch GTR440.4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crunch GTR440.4 in the language / languages: English, German as an attachment in your email.

The manual is 3,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info