1. LOCATION OF THE DEVICE
The thermostat of the
COMPUTHERM
Q7 RF
type device can be freely
moved in your residence. It is reasonable to locate it in a room used regularly
or for many hours per day so that it is in the direction of natural ventilation
in the room but protected from drought or extreme heat (e.g. direct sunlight,
refrigerator, chimney, etc). Its optimal location is 1.5 m above floor level. It can
be placed on its own stand or can be mounted on a wall.
IMPORTANT WARNING! If the radiator valves in your flat are equipped with
a thermostatic head, replace the thermostatic head of the radiator valve with
manual control knob or adjust it to maximum temperature in the room where
the room thermostat is to be located, otherwise the thermostatic head may
disturb the temperature control of the flat.
2. PUTTING THE THERMOSTAT INTO OPERATION,
BASIC SETTINGS
2.1 Inserting batteries
Pressing the lock on the upper side of the housing of the thermostat,
remove the back cover of the thermostat as shown in the figure below.
The battery compartment is in the inner side of the front panel of the
housing. Insert 2 AA alkaline batteries (LR6 type) in accordance with the
diagram in the battery compartment. After the batteries have been inserted,
the display flashes the day, time and program number as well as reference
and measured temperatures. (If this information fails to appear on the display,
press the „
RESET” button with a wooden or plastic stick. To press the button,
do not use any electrically conductive materials or graphite pencil). After the
batteries have been inserted, press the “SET” button. After the “SET” button
is pressed, the display stops flashing, the thermostat goes to the main screen
and the setting process can be started.
Vertical angle:
30 - 45°
Latch
- 4 -
