586751
1
Zoom out
Zoom in
Previous page
1/2
Next page
Maximum Performance
Radar/Laser Detector
SPX 6700
Operating Instructions
NOTE: This device complies with part 15 of FCC rules: Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received
including interference that may cause undesired operation.
CAUTION: Modifications or parts not approved by Cobra Electronics
Corporation may violate FCC Rules and void authority to operate this equipment.
Printed in the Philippines Part No. 480-888-P Version G
Thank you for purchasing Cobra’s maximum performance
radar/laser detector. Please read this manual to familiarize
yourself with the various features your detector offers.
Controls and Connections
Windshield Bracket
Mounting Slot
Power/Volume
Control
12V Power Jack
IntelliMute Button
Press to turn
IntelliMute On/Off.
Press & hold to set
IntelliMute.
Also enters IntelliMute
setting mode (see
IntelliMute section).
Mute/Set Button
Press once to manually
mute audio alerts.
Press & hold to switch
between Voice or Tone
Alert*
City Button
Press to select City
(filtering) Mode or
Highway Mode.
Press & hold to turn
Low Car Voltage
Warning On/Off.
Dim Button
Press to cycle through
different brightness
settings
.
Press & hold to turn
SmartPower On/Off.
Mounting
Your detector should be mounted on the windshield or dashboard of
your vehicle. Two mounting options are included:
Suction Cup Mount
This is the best option for portability and mov-
ing the detector from car to car. Make sure to
thoroughly clean the suction cups and wind-
shield mounting area to insure a tight seal.
Hook and Loop Fastener
Included for dashboard mounting.
Suction Cup Mount
Hook & Loop Fastener
Your detector should be mounted so that it is oriented
parallel to the road.
The suction cup mount comes standard bent at
a 45° angle. The metal is designed to bend
without breaking. Adjust the angle so when
mounted the detector is level with the road.
Avoid blocking the detector’s view by windshield wiper
blades or dark tinting at the top of the windshield.
Note: Do not attempt to bend the mount while the detector
is attached.
Windshield
Incorrect Positions
Correct Position
Powering
Plug in your detector using the included
cigarette lighter adapter.
Turn your detector on/off by pressing the
Power/Volume switch on the side of the
unit. The unit will light up.
12V Cigarette Lighter Adapter
12V Power Jack
Power/Volume Control
Types of Screens
1. Standby Screen
City/Highway Indicator: Shows current filtering mode.
Vehicle Battery Voltage: Displays your car battery voltage and
automatically warns you if this drops below 11.9V.
Car Battery Low Voltage Warning
In addition to displaying system voltage, your detector can pro-
vide a warning that battery voltage is low so that timely steps
can be taken to correct the problem. The Car Battery Low alert
is triggered when the voltage drops below 11.9 volts. Following
the alert, the unit enters SmartPower mode to avoid further
draining your car battery.
IntelliMute Indicator: Indicates status of IntelliMute.
See IntelliMute section for details.
Press to turn power
On and Off.
Push forward
or pull back to
adjust volume
.
2. Alert Screens
Radar bands consist of X-band, K-band, Ka-band, and Ku-band. With
radar signals, the signal strength meter shows the strength of the radar
gun as well as relative proximity to the source. With Ka-band, you will
also be notified of the actual Ka-band radar gun frequency being used.
With Laser signals, you will always receive full alert and pulse rate
(PPS) of the corresponding laser gun being used. Laser PPS currently in
use are: 100, 125, 130, 200, 238 and 340.
Ka Band Alert
Signal Strength
Frequency
Laser
Pulse
Rate
Level 1=
Weakest Signal
Level 5=
Strongest Signal
* See Buttons and
Controls chart for
additional information.
LaserEye
For 360° detection
of laser signals.
Buttons and Controls
Quad-level IntelliSheild
False Signal Rejection: Highway
Mode provides full immediate response to all signals detected.
Use this mode when you are driving on interstate highways.
Automatic door openers operate in X and K-band frequencies.
To minimize unwanted false alerts in an urban environment where
these sources exist, use one of the City Filtering Modes below:
City X:
automatically mutes X-band audible alert
until signal strength reaches level 3 or above.
City X+K: combined with City X,
automatically mutes K-band audible alert
until signal strength reaches level 2 or above.
City Plus X+K+Ka: combined with City X+K,
adds filtering to Ka-band.
City MAX: Maximum filtering against urban
false signal sources.
The City modes can also be adjusted by pressing the City button
for 2 seconds.
IntelliMute
®
: IntelliMute allows you to avoid audible alerts you
don’t need to hear because you are stopped or moving slowly. By
sensing the RPMs of your engine, IntelliMute knows when you
are at low speed and automatically mutes alerts. You can set
your preferred engine RPM activation point and/or turn on/off
IntelliMute by the IntelliMute button for more than 2 seconds.
You can change your detector’s user/alert settings by pressing one
or more of the Control buttons as shown below.
Function Press Button
Dim IMute Mute City
Single Button Press:
SmartPower On/Off >4 Seconds
IMute On/Off/ Pro <2 Seconds
IntelliMute-Set Activation RPM >2 Seconds
Auto Mute On/Off <2 Seconds
Voice/Tone >2 Seconds
Double Button Press:
Low Car Voltage Warning On/Off >2 Seconds
X Band On/Off
>4 Seconds
Ku Band On/Off >4 Seconds
Safety Alert On/Off >4 Seconds
VG-2 and Spectre On/Off >4 Seconds
POP Alert On/Off >4 Seconds
SPX6700_MANL_v.G.indd 1 3/12/15 11:43 AM
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra SPX 6700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra SPX 6700 in the language / languages: English as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info