634453
21
Zoom out
Zoom in
Previous page
1/24
Next page
3. AFTER USE
1). Switch the product off, disconnect it from the power
supply and let it cool down.
2). Check, clean and store the product as described below.
4. GRASS CATCHER
1). Inspect the grass catcher (15) before each use. Do not
use it if you find any damage.
2). Clean the grass catcher (15) after operation. Let the
grass catcher dry thoroughly before storing to avoid mildew.
5. TRANSPORTATION
1). Switch the product off and disconnect it from the power
supply before transporting it anywhere.
2). Attach transportation guards, if applicable.
3). Adjust the cutting depth to the transportation setting (refer
to “CUTTING DEPTH ADJUSTMENT”).
4). Always transport the product using its handle.
5). Protect the product from any heavy impact or strong vibrations
which may occur during transportation in vehicles.
6). Secure the product to prevent it from slipping or falling
over.
TROUBLESHOOTING
WARNING! Only perform the steps described in these instructions! All further inspection,
maintenance and repair work must be performed by an authorised service specialist! Contact
your local authorised service dealer if the problem cannot be solved by yourself!
WARNING! If the pr
oduct does not perform properly, makes unusual sounds, the motor
does not start or stop as described, the cutting device does not work properly, or any other
irregularity or malfunction occurs, do not attempt to repair the product by yourself. Please
contact customer services or your local authorised service dealer.
Problem
Possible cause
Fault correction
Product does not start
Not connected to power supply
Connect to power supply
Power cord or plug is defective
Check by a specialist electrician.
Other electrical defect to the
product
Check by a specialist electrician.
Lock-off button not pressed
Press lock-off button first, then
the start/stop lever
Product does not reach
full power
Power source’s (e.g. generator)
voltage is too low
Connect to another power source
Air vents are blocked
Clean the air vents
Poor results
Cutting device is dull/damaged
Replace with a new one
Scarified material exceeds
capacity
Only scarify materials according
to the capacity of the product
Scarifying depth is incorrect
Adjust depth
26/02/2013 v1
21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra S32E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra S32E in the language / languages: English as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info