773870
10
Zoom out
Zoom in
Previous page
1/12
Next page
7. FAQs
PROBLEM PROBABLE CAUSE SOLUTION
The room does not reach
the desired temperature
Incorrect setting of the set
temperature.
Check the set temperature on the display to verify it is the
desired temperature.
Improper sizing, the heater
is too small for the room.
The power rating of the heater is not adequate for the place
in which it has been installed. Select a larger heater.
Lower and Upper grids are
obstructed.
Do not place anything on top or below the radiator.
Set temperature below the
room temperature.
Rise the radiator’s set temperature until it is 1 degree above
the room temperature.
The radiator does not
operate.
The /esc button has been
pressed and the heater is
turned off.
Press the /esc button and turn on.
(the display shows ON)
The switch at the side of the
heater is turned to the off
position.
Set the switch at the right side of the heater to position 'I'.
The set program is in an
OFF period.
Check that the set program is correct for the time period
and change if necessary or put in manual mode and
override.
Appearance of stains on
the wall just above the
radiator.
Dust, Carpet fibers or
smoke fumes going through
the heater.
Vacuum any dust and loose carpet fibers below the heater.
Reframe from burning candles or smoking in the same
room.
The display does not work
Disconnection from power
supply.
Make sure the power going to the device and is turned on.
No response from buttons
Control panel has been
locked to prevent pressing
of buttons.
Refer to key locking function section 3.7
The display shows a red
dot.
After a short amount of time
if no buttons have been
pressed the display goes
into stand-by mode.
Press any button and the display will activate
Temperature does not go
below 15ºC.
The heaters temperature is
at its limit.
The heaters temperature range is 15-28ºC.
The display shows
“dashes” The device is blocked Press button POWER/ESC during 4 seconds and press the
DOWN arrow.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Climastar Silicium Touch Bathroom at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Climastar Silicium Touch Bathroom in the language / languages: English as an attachment in your email.

The manual is 1.59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info