703910

Cleanmaxx Z PWM2K Manual

2
Zoom out
Zoom in
Previous page
1/4
Next page
EN Instructions
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
✆ +49 38851 314650 *)
*) Calls to German landlines are subject to charges. The cost varies
depending on the service provider.
All rights reserved.
Dear customer,
We are delighted that you have chosen our cleaning mop set.
Before using the product for the fi rst time, please carefully read
through these instructions and store them in a safe place.
If you have questions about the device or spare parts/accessories,
contact customer service via our website:
www.service-shopping.de
Explanation of Symbols
Safety instructions: Read these carefully and follow
them to prevent personal injury and damage to prop-
erty.
Explanation of the Signal Words
WARNING warns of possible serious injuries and danger to
life
CAUTION warns of slight to moderate injuries
NOTE warns of damage to property
IMPORTANT NOTES
■ This product is suitable for wet cleaning all kinds of surfaces
(fl oors, stairs, furniture, etc.).
■ The product is designed for private use and is not intended for
commercial use. Only use it as described in the instructions.
Any other use is deemed improper.
■ WARNING – Danger of Suffocation! Keep the article and the
packaging material away from children and animals.
■ CAUTION – Risk of injury associated with rotatable parts!
Do not leave children and animals alone with the device
without supervision.
■ CAUTION – Risk of injury! Do not reach into the rotating
sieve and/or the mechanical parts behind the pedal.
■ Do not fi ll the bucket with too much water to avoid spilling water.
■ Use the carrying handle to move the bucket.
■ The mop attachment can be washed in the washing machine
at up to 60 °C. Do not use any softeners! Only air dry the mop
attachment – do not in any case do so in a laundry dryer or
with a hair dryer!
■ Only use accessories from the manufacturer.
■ Protect the device from heat sources, naked fl ames, sub-zero
temperatures, direct sunlight and impacts.
Product contents and product overview
(Illustration similar)
1 Upper part of the pole (with
handle)
2 Intermediate part of the pole
(2 x)
3 Bottom part of the pole with
mop
4 Mop attachment holder
5 Mop attachment
6 Removable fi lter
7 Hook for mounting the fi lter
8 Pedal
9 Rotating sieve
10 Carrying handle
1
2
3
4
10
9
8
5
6
7
Assembly
• Unpack the items supplied and check them for completeness
and for possible transport damage. If you should fi nd any
transport damage, do not use the article(!), but contact the
customer service department.
• Screw the 4 parts of the pole together.
• Removing the fi lter from the bucket: Push the two side hooks
up. Then you can remove the fi lter.
• Inserting the fi lter: Push the fi lter into the groove in the bucket
until it locks into place.
• Attaching the mop attachment:
1. Place the mop attachment on the fl oor.
2. Set the mop attachment holder at the bottom end of the
pole on the mop attachment’s plastic ring.
3. Push the pole down until the holder and ring audibly lock
into place.
• Removing mop attachment
1. Rotate the mop in the air and then place it on the fl oor so
that all the strands are spread out around it.
2. Fix the mop attachment in place by placing your feet on
the strands.
3. Firmly hold onto the bottom pole part and then swiftly pull
it up to release the mop attachment from the mop holder.
4. You can now wash the mop attachment out or replace it.
Use
1. Fill the bucket with water and a small amount of cleaner. Do not
overfi ll the bucket! Make sure that the cleaner you are using is
suitable for the surface to be cleaned.
2. Immerse the mop in the bucket.
3. Place the mop on the centering aid in the rotating sieve. The
strands must completely be located in the rotating sieve.
4. Gently hold by the handle so that the pole is in a vertical
position. Do not push the pole down!
5. Quickly push the pedal down a few times. Make sure that you
lift your heel in the process; otherwise you may not attain the
speed needed to extract moisture from the mop.
6. If the mop is damp, but no longer wet, use it to mop the surface
you intend to clean as usual.
7. To rinse off the mop attachment, dip it back in the water and
move it up and down several times. Then wring it out as
described.
8. Once you have fi nished using the mop, you can remove the
mop attachment and wash it (see section “Assembly”). You
should also rinse the bucket out. We recommend you remove
the fi lter for this.
Variations
• Article number: 07203 (red)
• Article number: 09080 (black-white)
• Article number: 09746 (limegreen)
Disposal
Dispose of the packaging material in an environmentally
friendly manner and take it to a recycling centre. Dispose
of the product in an environmentally-friendly manner, too.
For more information, contact the administrative body in
your community.
Z PWM2K M DS V4 0718
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleanmaxx Z PWM2K at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleanmaxx Z PWM2K in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info