646294

Cleanmaxx Z 08336 - JJ-SC-005B Manual

26
Zoom out
Zoom in
Previous page
1/60
Next page
26
❐ Never apply the vapour stream to one area for more than approximately 10 seconds.
Otherwise, it could damage the surface.
Cleaning the fl oor
It is recommended that you briefl y sweep the fl oor surface with a broom or vacuum
it before using the appliance.
1. Mount the handle bar with the handle and the cleaning head on the main unit. Attach
the fl oor pad to the cleaning head and, if you would like to clean a carpet, the carpet
cleaning head (see chapter “Assembling the appliance”).
2. Fill the water tank (see chapter “Filling the water tank”).
3. In order to unwind the power cord, turn the top hook of the cord spool down. Hang the
power cord in the cord holder (3) for better handling of the steam cleaner when cleaning
fl oors and so that you do not trip over the cord.
4. Turn the knob for the steam quantity control (8) to the minimum set-
ting by turning it counterclockwise until it comes to a stop.
5. Park the appliance in an upright position. The hinge of the cleaning
head locks in when in an upright position.
6. Insert the mains plug in a properly installed socket that is easily accessible. The power
LEDs (12) behind the water tank will illuminate in red as soon as operating voltage is
present. Wait until the appliance has reached the operating temperature and the power
LEDs are blue.
7. Now you can start to clean the fl oor. Push the
On / Off switch (4) on the front of the
main unit. (The switch on the back (13) has been deactivated when the handle bar is
inserted.) Steam will begin to be emitted from the cleaning head. You can now increase
the quantity of steam by turning the knob for the steam quantity control.
NOTE: After the knob is turned, it will take a few seconds until the respective steam
quantity is reached.
8. Hold the appliance by the handle and tip it slightly towards the fl oor in order to release
it from the upright locking position.
9. Slowly slide the cleaning head back and forth over the fl oor. The fl oor will be cleaned
in the process.
10. When the power LEDs blink red, there is too little water in the tank. Push the
On / Off
switch before you fi ll the tank. Before you wash out the fl oor pad or once you have fi n-
ished cleaning the fl oor, push the
On / Off switch and pull the mains plug out of the
socket. Never pull on the cord, but always on the plug.
11. Wait a few minutes for the appliance to cool off before you remove the fl oor pad. Be
aware that when turning off the appliance a wet area can form beneath the clean-
ing head.
12. Follow the instructions in the section “After use”.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleanmaxx Z 08336 - JJ-SC-005B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleanmaxx Z 08336 - JJ-SC-005B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info