562002
20
Zoom out
Zoom in
Previous page
1/44
Next page
20
Cleaning the carpet
ATTENTION!
Do not use the device as a conventional vacuum cleaner.
Always make sure that there is no risk of the device tipping over. The water could leak
out of the water tanks. To stow the device, position the handle in an upright position so
that it locks into place.
Never leave the device unattended while switched on.
Turn off the device before you remove a water tank.
Do not excessively wet the carpet.
1. Determine where you want to start and stop cleaning without stepping on the area
of the carpet that was just cleaned. We recommend that right-handed persons
start on the right carpet edge and left handed persons start on the left carpet edge.
Cleaning solution may leak out of device once it is switched off. For this reason, have
a cloth laid out ready that you can place the device on after use.
2. Completely unwind the mains cord from the hook (10), insert it in the cord holder (14)
and connect it with an easily accessible socket whose mains voltage corresponds to
the device’s technical data.
3. Push the On/Off switch (13) to the I position to turn on the device.
4. Step on the pedal (12) and tilt the handle to a position that is
comfortable for you.
5. Roll the device to a corner of the carpet.
6. Push the device forwards along the carpet edge and press
and hold the button for emitting the cleaning solution (9).
This will apply and brush the cleaning solution into the car-
pet. In the process, walk next to the device. Do not step on
the wet carpet! Once you have arrived at the other end of
the carpet, release the button.
7. Now go over the same strip in reverse. The dirty water will be vacuumed up.
8. Start the next strip slightly overlapping the cleaned carpet strip. Work with even for-
ward and backward movements up to the other edge of the carpet. In the event of
stubborn dirt, go over a strip of the carpet several times if necessary.
9. Once the dirty water tank (7) lls up to the Max mark, it will have to be emptied (see
chapter “After use”, section “Cleaning the device”).
10. If you would like to empty the dirty water tank, ll the fresh water tank or end the clean-
ing process, place the device on the cloth you laid out. Turn it off (switch set to 0) and
bring the handle to an upright position.
11. Remove the power plug from the socket.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleanmaxx Z 01037 - VC9388 Carpet Cleaner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleanmaxx Z 01037 - VC9388 Carpet Cleaner in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info