580504
18
Zoom out
Zoom in
Previous page
1/21
Next page
English
Owner’s Manual
CMS2
18
1. This set is exclusively for use in vessels with a negative
ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “–” terminal
before starting. This is to prevent short circuits during
installation. (Figure 1)
1. In order to avoid any interference, do not install the tuner module or control unit in the proximity of the engine
compartment.
2. The use of unauthorized parts can cause permanent damage to the unit.
3. Always check your wire connections to ensure proper installation before turning on the unit.
4. Consult with your nearest dealer for proper installation or if common parts need to be used. Seek assistance if
modifications or drilling holes to your vessel is needed.
5. Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign particles or vibration. Areas
of high temperature from the engine, direct sunlight, heater or hot air should also be avoided.
6. Do not install the unit in a location where it will interfere with the vessel operation, or it will injure the passengers if
there is a sudden or emergency stop.
1. The control unit should be mounted to a dry, clean and flat surface. Ensure the rear gasket is fully sealed to the
mounting surface without distorting the unit.
2. Select one of the three recommended methods that best fit your vessel.
INSTALLATION AND WIRE
CONNECTION
1. BEFORE STARTING
2. INSTALLATION CAUTIONS
3. DISPLAY CONTROLLER INSTALLATION
Battery
Figure 1
This method requires the
purchase of the optional
BKU001 Gimbal mount
accessory
Method 3
Method 2Method 1
M4 Tapping
Screw
4 Pcs
M4 Tapping
Screw
4 Pcs
8-Pin DIN Cable
8-Pin DIN Cable
8-Pin DIN
Cable
Flush Mount
Flush Mount
Mounting
Bracket
Screw Hole
Screw Hole
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clarion CMS2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clarion CMS2 in the language / languages: English as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info