555410
14
Zoom out
Zoom in
Previous page
1/16
Next page
14
Care Of Your Opener
When properly installed, opener will provide high
performance with a minimum of maintenance. The
opener does not require additional lubrication.
Limit and Force Adjustments: These adjustments must
be checked and properly set when opener is installed.
Onlyascrewdriver isrequiredto adjust thelimits.Weather
conditions may cause some minor changes in the door
operation, requiring some re-adjustments, particularly
during the first year of operation. Refer to the Limit and
Force Adjustments on page 2. Follow the instructions
carefully and repeat the safety reverse test after any
adjustment.
Remote Control Transmitter: Additional Remotes can
be purchased at any time for use in all vehicles using
garage. Refer to Accessories.The receiver must be
programmed to operate with any new Remote.
Remote Control Battery: The lithium batteries should
produce power for up to 5 years. If transmission range
decreases, replace battery.
To Change Battery: Insert batteries positive side up. To
replace cover, snap shut along both sides.Do not dispose
of the old battery with household waste.Take batteries to
a proper disposal center.
Maintaining Your Opener
Apply grease to rail and trolley
Oil door rollers, bearings and hinges
DO NOT lubricate the opener itself
DO NOT APPLY grease to the door tracks
TROUBLE SHOOTING
1. Opener doesn’t operate from remote:
Does the opener have electric power? Plug lamp into outlet. If it
doesn’t light, check the fuse box or the circuit breaker. (Some outlets
are controlled by a wall switch.)
Have you disengaged all door locks? Review installation instruction
warning on page 1.
Try a new battery.
If you have two or more remotes and only one operates, review
r
eceiver programming procedures in Step 21.
Is there a build-up of ice or snow under door? The door may be
f
rozen to ground. Remove any obstruction.
The garage door spring may be broken. Have it professionally
replaced.
2. Remote has short range:
Is battery installed? Try a new one.
Change the location of the remote control in the car.
The metal garage door, foil-backed insulation or metal siding will
r
educe the transmission range.
3. Door reverses for no apparent reason and opener lights don’t
blink:
Is something obstruction the door? Pull Manual Release Handle.
Operate door manually. If it is unbalance or binding, call for profes-
sional garage door service.
Reprogram the Force.
Clear any ice or snow from garage floor area where garage door
closes.
If door reverses in fully closed position, adjust the Close Limit.
Repeat safety reverse test after adjustment is complete.
The need for occasional adjustment of the Limit positions is normal.
Weather conditions in particular can affect door travel.
4. Door reverses for no apparent reason and door control button
light blinks for 5 seconds after reversing:
Check The Protector System™ (if you have installed this accessory).
if the light is blinking, correct alignment.
TROUBLE SHOOTING CONTINUED
5. The garage door opens and closes by itself:
(Keypad or Code Switch transmitters only) Is there a neighbor with a
garage door opener using the same code? Change your code.
Make sure remote push button is not stuck in ON position.
6. Door does not close completely:
Adjust the Close Limit.
Repeat safety reverse test after any adjustment of door arm length,
or Close Limit.
7. Door opens but won’t close:
Check The Protector System™ (if you have installed this accessory).
If the light is blinking, correct alignment.
Repeat the safety reverse test after the adjustment is complete.
8. Opener light does not turn on:
Replace light bulb (21 Watts maximum).
9. Opener light does not turn off:
Defective logic board.
10. Opener motor hums briefly, then won’t work:
Garage door springs are broken. Close door and use Manual
Release Rope and handle to disconnect Trolley. Open and close door
manually. A properly balanced door will stay in any point of travel
while being supported entirely by its springs. If it does not, call for a
professional garage door service to correct the problem.
If problem occurs on first operation at opener, door may be locked.
Disable door lock.
11. Opener won’t activate due to power failure:
Pull Manual Release Handle to disconnect Trolley. Door can be
opened and closed manually. The next time opener is activated, the
Trolley will reconnect.
The Outside Quick Release accessory 1702AML (if fitted) discon-
nects the Trolley from outside the garage in case of power failure.
Specifications
I
nput Voltage . . .. . . . . . .. .230 VAC 50/60 Hz
Max. Pull force . . . .. .. . . .600N
Rated Power Input . . . .. . .85 Watts
Rated Load . .. . . . .. .. . . .3.0 Nm
Standby Power . . . .. . . . . .9 Watts
M
ax. Door Weight . . .. . . . .60kg
Motor
T
ype . . . . . . .. . . . . . .. . . .63:1 Worm Gear Reduction
Volts . .. . . . . . .. . . . . . .. .24VDC
Drive Mechanism
Length of Travel . .. . . . . . .2.3M
Travel Rate . .. . . . . . .. . . .8cm/sec
L
amp . .. . . . . . .. . . . . . .. .24V 21 Watts
Safety
Electronic . . . . . . .. . . . . . .Auto-Force Adjustment
Electrical . . . .. . . . . . .. . . .Thermal Fuse in Transformer
Limit Adjustment . . . .. . . . .Manual
D
imension
Length (Overall) . . . . . .. . .2.75m
H
eadroom Required . . . .. .30mm
Hanging Weight . . . .. . . . . .9kg
Receiver Code Registers
Rolling Code . .. . . . . . .. . .8
Keypad . .. . . . . . .. . . . . . .1
O
perating Frequency . . . . .433.92MHz
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chamberlain ML500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain ML500 in the language / languages: English as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info