Manual Celestron Omni XLT AZ - 22152 (page 3 of 40) (English, German, French, Italian, Spanish)

667006

Zoom out

Zoom in

1/40

ENGLISH | 3

The Omni XLT AZ mount and tripod come fully assembled,

so setting it up is easy.

1. Remove the tripod and mount from the box.

2. Loosen the hand knobs at the bottom of each leg and

extend the inner section of the leg to the desired length.

Tighten the knobs to secure the legs, being careful not

to over tighten.

3. Stand the tripod upright and pull the tripod legs apart

until the center brace snaps into place.

4. Place the accessory tray on top of the center brace and

line up the holes. Insert the three thumb screws through

the bottom of the leg brace and thread them into the

tray.

5. Make sure the leg hinge bolts are secure by snugging

down the black thumbnuts at the top of each leg.

Depending on your speciﬁc use of the telescope, you may

wish to change the angle of the mount arm to give you

additional range of motion. The mount comes set up for

the astronomical use; it can move upward but is limited

in its downward motion. If you are using the mount for

terrestrial observation from an elevated location (cliff top,

balcony, etc.) and you want to point the scope well below

the horizon, you will need to change the angle of the mount

arm to accommodate this.

To make this adjustment:

1. Unthread the round cover on the bottom of the vertical

arm of the mount.

2. Using a 4 mm hex-key wrench (user supplied), remove

the three screws under the cover.

3. Rotate the mount arm so that it is pointed straight up and

thread the three screws back in.

4. Tighten the screws and replace the round cover.

ASSEMBLING YOUR TELESCOPE

ADJUSTING THE ANGLE OF THE MOUNT ARM

THE MOUNT

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Celestron Omni XLT AZ - 22152 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1,98 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Celestron Omni XLT AZ - 22152 Manual

Product: