Manual Cateye ENDURO 2 - CC-ED200 (page 3 of 4) (English)

637214

Zoom out

Zoom in

1/4

(2)

(1)

(2)

(1)

2mm

(3)

(4)

1 4

CAT EYE MITY3

CC-MT300

1 Bracket

2 Wire

3 Sensor

4 Sensor Bands-A

5 Sensor Band-B

6 Magnet

7 Sensor Band Rubber Pad

8 Bracket Rubber Pad

9 Nylon Tie

0 Sensor Band Screw

Attach the sensor temporarily.

Note: Sensor Band-A

(Small) --------- 11Ø-26Ø

(Large) --------- 21Ø-36Ø

Align the magnet's center(1) and the

sensor's marking line(2). Make sure of

approx. 2mm clearance between the magnet

6 and sensor 3.

Test

Slide the main unit onto the bracket according to " How to Attach Main Unit to

Bracket" (below). Make sure the computer is fully attached to the bracket. Spin the

front wheel and check if the speed display appears. (If not, adjust the relative posi-

tions of magnet and sensor again.) Fasten the sensor securely, and remove the

main unit.

Secure the wire along the fork with the

nylon ties 9, and wind it round the brake

cable(3) up to the handlebar.

Note: Allow enough wire length in the

area marked with

in the illus-

tration, to insure full movement

and unhindered operation of the

handlebar.

Test the alignment of the magnet and sensor with the main unit attached.

How to Attach Main Unit to

Bracket

Slide main unit onto the bracket from front until

it clicks into position. To remove, pull it off for-

ward while pushing down the lever(4).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Cateye ENDURO 2 - CC-ED200 in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Cateye ENDURO 2 - CC-ED200 Manual

Product: