538691
3
Zoom out
Zoom in
Previous page
1/41
Next page
3
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
OthersIntroduction
Procedure of automatic recognition
The computer automatically recognizes the sensor ID according to the following procedure.
1
Signals from each sensor (speed, speed/cadence, cadence, heart rate, and power) are
searched at the time when the GPS search screen displayed when the power is turned
on, or the standby screen is changed to the measurement screen.
Caution: Any sensor that is not sending the sensor signal at this time cannot be
recognized. Each sensor sends the sensor signal in response to the
following operations.
Sensor type Method
Speed sensor
Move the magnet close to the sensor zone
(at a distance of less than 3 mm)
Speed/cadence (ISC) sensor
* When using the CATEYE speed/ca-
dence sensor (ISC-11), select [ISC]
to perform paring.
Cadence sensor
Heart rate sensor Wear the heart rate sensor
Power sensor Ride the bicycle lightly
2
Among the pairing-performed IDs of each sensor, the sensor with the strongest signal
is received. The sensor signal icon corresponding to the received sensor appears on the
display, and measurement is started. Each sensor is displayed as follows.
Sensor type Display
Speed sensor
S
Speed/cadence (ISC) sensor
S and C flash simultaneously
Cadence sensor
C
Heart rate sensor
H
Power sensor
P
* The computer performs measurement using the GPS signal when the speed signal from
the speed sensor or speed/cadence (ISC) sensor cannot be received. In such a case, the
computer changes to measurement using the speed sensor whenever the speed signal is
detected.
* When the cadence signal, heart rate signal, or power signal cannot be received, the rel-
evant measurement value is not displayed.
GPS
GPS (Global Positioning System) is a system to identify the current position on the earth by
receiving highly precise positional information sent from a satellite.
Receiving the GPS signal
• It may take several minutes to acquire the GPS signal after turning on the computer.
• While searching the GPS signal, we recommend that you do not move around until receiv-
ing the GPS signal. It may take more time to receive the GPS signal if you move around
while searching the GPS signal.
• Receiving the GPS signal becomes easier under such conditions that the sky is open and
the prospect for the satellites is good.
Where the GPS signal cannot be received
The unit may stop measurement or may not display appropriate measurements when the
GPS signal cannot be received in the following locations or environments.
• In a tunnel, underground and building, between high-rise buildings, under an elevated
structure and arcade, etc.
• In bad weather (snow, rain, etc.)
• Near a high-voltage line or a mobile telephone relay station.
• When the computer display does not face to the sky.
* The measurement results may differ slightly from the actual values, when the speed is
calculated based on the GPS signal.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cateye CC-GL50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cateye CC-GL50 in the language / languages: English as an attachment in your email.

The manual is 3,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cateye CC-GL50

Cateye CC-GL50 User Manual - German - 41 pages

Cateye CC-GL50 User Manual - Dutch - 41 pages

Cateye CC-GL50 User Manual - French - 41 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info