508112
26
Zoom out
Zoom in
Previous page
1/28
Next page
26
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Changing the
computer con-
figuration
Uploading the mea-
surement data
Setup of your
PC
Others
Troubleshooting
The following troubles are not due to failure.
See also “FAQ” in CATEYE Atlas™ (web) (http://www.cateyeatlas.com/qa/).
Trouble Check Items Remedy
The measurement data
is wrong.
Measurement may stop, or the
measurements may differ from the
actual value depending on the GPS
receiving status, since this unit
measures using GPS signal.
MEM FULL flashes. Does the maximum re-
cording time or the num-
ber of trips exceed the
upper limit?
* For details, see “Record
interval and capacity
limit” (page 16)
Connect the computer to your PC
to upload the trip data (page 13).
All the trip data transferred to your
PC will be deleted from the com-
puter, and new data will be able to
be recorded.
Does the maximum time
for one trip exceed the up-
per limit?
* For details, see “Record
interval and capacity
limit” (page 16)
Perform the resetting operation
(page 10) to stop the current trip.
Then, you can record as another
trip.
The backlight does not
light up even at the
preset hour.
Are the start time and end
time set to the same hour?
The backlight does not light up
when the start time and end time
are set to the same hour.
For information on how to set the
start/end time, see “Changing the
computer configuration” (page 20).
The backlight lights up
during the daytime.
Is the start time of the
night-time set correctly?
For information on how to set the
start time, see “Changing the com-
puter configuration” (page 20).
Trouble Check Items Remedy
When the power is
turned on,
(bat-
tery icon) flashes, and
then no display ap-
pears.
Remaining battery capacity is
nearly zero.
Charge the computer according to
the procedure in “How to charge”
(page 5).
The power is turned off
while riding.
The power is turned off automati-
cally in 10 minutes without GPS
signal received.
(Auto power off)
No display appears by
pressing and holding
the
button for 2 sec-
onds.
Is the battery for the com-
puter empty?
Charge the computer according to
the procedure in “How to charge”
(page 5).
Incorrect data appear.
Follow the procedure in “When the
operation is unstable” (page 25).
Measurement cannot
be performed
(
flashes on the
display).
Is it immediately after
turning on the power?
It may take about 2 to 3 minutes to
acquire the positional information
after receiving GPS signal.
Is it out of the GPS service
area?
GPS signal does not reach, thus
cannot be received in a tunnel and
underground, between high-rise
buildings, under an elevated struc-
ture, etc.
Is the weather not suitable
for receiving GPS signal?
GPS signal may not be received
when it is raining or snowing.
Is the unit installed so that
the computer display (an-
tenna) faces to the sky?
To receive GPS signal effectively,
install the unit so that the computer
display faces to the sky.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cateye CC-GL10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cateye CC-GL10 in the language / languages: English as an attachment in your email.

The manual is 3,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cateye CC-GL10

Cateye CC-GL10 User Manual - German - 28 pages

Cateye CC-GL10 User Manual - Dutch - 28 pages

Cateye CC-GL10 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info