624893
5
Zoom out
Zoom in
Previous page
1/6
Next page
Operation Guide 5481
E-49
Countdown Timer:
Measuring unit: 1 second
Countdown range: 24 hours
Countdown start time setting range: 1 minute to 24 hours (1-minute increments)
Alarms: 5 daily alarms; Hourly time signal
Illumination: LED (light-emitting diode); Selectable illumination duration
(approximately 1.5 seconds or 3 seconds)
Other: Button operation tone on/off; Moving the Hands to View the Digital Display
Power Supply: Two silver oxide batteries (Type: SR726W)
Approximate battery operating time: 2 years under the following conditions:
x 1 illumination operation (1.5 seconds) per day
x Alarm: 10 seconds/day
Frequent use of illumination runs down the battery.
E-48
Specifi cations
Accuracy at normal temperature: ±30 seconds a month
Digital Timekeeping: Hour, minutes, seconds, p.m. (P), month, day, day of the
week
Time format: 12-hour and 24-hour
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: Home City code (can be assigned one of 48 city codes);
Standard Time/Daylight Saving Time (summer time)
Analog Timekeeping: Hour, minutes (hand moves every 20seconds)
Counter: 0 to 999
World Time: 48 cities (31 time zones)
Other: Daylight Saving Time/Standard Time
Stopwatch:
Measuring unit: 1/100 second
Measuring capacity: 59 minutes, 59.99 seconds
Measuring modes: Elapsed time, split time, two fi nishes
E-47
Main Indicators
Number Name See
1
1
Modes E-10, E-11
2
2
PM indicator E-15
3
3
Hands shifted indicator E-13
4
4
Alarm indicator E-39
5
5
Hourly time signal indicator E-39
6
6
DST indicator E-18, E-26
1
1
4 5 6
2 3
E-46
Troubleshooting
Time Setting
The current time setting is off by hours.
Your Home City setting may be wrong (page E-16). Check your Home City setting and
correct it, if necessary.
The current time setting is off by one hour.
You may need to change your Home City’s standard time/daylight saving time
(DST) setting. Use the procedure under “Adjusting the Digital Time and Date
Settings” (page E-19) to change the standard time/daylight saving time (DST) setting.
World Time Mode
The time for my World Time City is off in the World Time Mode.
This could be due to incorrect switching between standard time and daylight saving
time. See “To specify standard time or daylight saving time (DST) for a city” (page E-26)
for more information.
E-45
3. Press D to toggle the setting between KEY (ON) and MUTE (OFF).
4. After all the settings are the way you want, press A to exit the setting screen.
E-44
Button Operation Tone
You can turn the button operation tone on or off as
desired.
x Even if you turn off the button operation tone, alarms,
the Hourly Time Signal, and other beepers all operate
normally.
To turn the button operation tone on and off
1. In the Timekeeping Mode, hold down A until ADJ
appears.
x This indicates the city code setting mode.
x The hour and minute hands automatically move out of
the way at this time (page E-12).
2. Press C nine times to display the button operation tone On/Off screen (page E-20).
The screen will show either KEY
or MUTE.
E-43
3. Press C.
x This enters the hour and minute hand adjustment
mode.
x Press C again* to return to the mode hand
adjustment mode.
* Nothing will happen if you press C while the hands
are moving.
4. If the hour and minute hands are not at 12 o’clock,
use D and B to adjust them until they are.
5. Press A to return to the Timekeeping Mode.
Check to make sure that the time indicated by the hands matches the time on the
digital display. If the times don’t match, perform the correction procedure above
again.
Hour hand and minute hand
E-42
Adjusting Hand Positions
The watch hands can go out of alignment with the time on the digital display if it
is exposed to strong magnetism or impact. If this happens, you should adjust the
hand positions.
Important!
x You do not need to perform the operation below as long as the analog hands
indicate the same time as the digital display.
1. In the Timekeeping Mode, hold down A for about fi ve
seconds until H.SET appears.
x This indicates the mode hand adjustment mode.
x Though ADJ will appear as you hold down A, do not
release the button yet.
2. If the mode hand is not at 12o’clock, use D and B
to adjust until it is.
Mode hand
E-41
2. Press C 10 times to display the illumination duration
setting screen (page E-20).
The screen will show either LT1 or LT3.
3. Press D to toggle the illumination duration setting
between LT1 (1.5 seconds) and LT3 (3 seconds).
4. After all the settings are the way you want, press A to
exit the setting screen.
E-40
Illumination
The face of the watch is illuminated for easy reading in the dark.
To illuminate the face
In any mode (except a setting mode), press B to illuminate the face.
Illumination Precautions
x Illumination may be hard to see when viewed under direct sunlight.
x Illumination turns off automatically whenever an alarm sounds.
x Frequent use of illumination runs down the battery.
To change the illumination duration
1. In the Timekeeping Mode, hold down A until ADJ appears.
x This indicates the city code setting mode.
x The hour and minute hands automatically move out of the way at this time (page
E-12).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5481 - BGA-185 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5481 - BGA-185 in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5481 - BGA-185

Casio 5481 - BGA-185 User Manual - German - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info