624830
13
Zoom out
Zoom in
Previous page
1/13
Next page
Q2
The signal receive operation always
fails.
Is the watch in a location that is appropriate
for signal reception?
Check your surroundings and move the
watch
to a location where signal reception
is better.
l Appropriate
Signal Reception Location
Did you avoid touching the watch while the
receive operation was in progress?
Minimize movement of the watch and do
not perform any watch operation while a
receive operation is in progress.
Is the signal transmitter in your area
transmitting a signal?
The transmitter of the time calibration may
not be transmitting a signal.
Try again later.
Q3
Signal reception should have been
successful,
but the watch’s time and/
or day is wrong.
Do the hand and/or day indicator look out
of alignment?
Correct hand and day indicator alignment.
l Adjusting Hand and Day Indicator
Alignment
After checking the above, the time and/or
day settings is still wrong.
Adjust time and day settings manually.
l Adjusting Time Settings Manually
Hand Movement and
Indications
Q1
I don’t know what mode the watch is
in.
Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
Take care not to hold down (C) too long.
Holding
down (C) for about four seconds will
enter or exit the Airplane Mode.
l Navigating Between Modes
30
Q2
The second hand is jumping at two-
second or five-second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
l Charging the Watch
Q3
All
hands are stopped and buttons do
not work.
The battery is dead. Keep the watch exposed
to light until it recharges sufficiently.
l Charging the Watch
Q4
The hands suddenly start moving at
high speed.
This is due to one of the reasons below, and
does not indicate malfunction. Simply wait
until normal hand movement resumes.
The watch is recovering from a power
saving state.
l Power Saving Function
The
hands are moving to their new positions
following a GPS signal or time calibration
signal receive operation.
l Time Adjustment (GPS, Time Calibration
Signal)
Q5
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for
about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q6
Why is the current time indicated by
the watch is off by a large amount of
time (nine hours, three hours and 15
minutes, etc.)?
The city (time zone) setting is not correct.
Select the correct setting.
l Acquiring GPS Position Information
Manually
l Selecting a Time Zone
Q7
The current time indicated by the
watch
is off by one hour or 30 minutes
The summer time setting is not correct. Select
the correct setting.
l Acquiring GPS Position Information
Manually
l Selecting a Time Zone
Q8
Hands
and/or the day indicator is out
of alignment.
Strong magnetism or impact may cause the
hands of the watch to go out of alignment.
Correct hand position alignment.
l Adjusting Hand and Day Indicator
Alignment
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately
30 minutes in the case of hand
and day indicator alignment operations),
crown operations will automatically become
disabled. Push the crown back in to its normal
position and then pull it out again.
l Using the Crown
Operation Guide 5454
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5454 - OCW-G1100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5454 - OCW-G1100 in the language / languages: English as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5454 - OCW-G1100

Casio 5454 - OCW-G1100 User Manual - German - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info