586700
5
Zoom out
Zoom in
Previous page
1/8
Next page
Operation Guide 5369 (MTG)
E-39
Using the Countdown Timer
The countdown timer can be confi gured within a range of one minute to 120 minutes. An alarm sounds for
about 10 seconds when the timer reaches zero.
Hand Functions
z
z Hour Hand
x
x Second Hand
c
c Minute Hand
v
v Hour Hand (24-hour)
b
b Small Minute Hand: Indicates countdown seconds.
n
n Small Hour Hand: Indicates countdown minutes
(1 revolution = 60 minutes).
m
m Small Hour Hand (24-hour): Indicates countdown minutes
(1 revolution = 120 minutes).
,
, Lower Dial Hand: Points to TR.
x All hands move counterclockwise during a countdown.
To enter the Countdown Timer Mode
Refer to the Mode Reference Guide (page E-21).
x Entering the Countdown Timer Mode will cause the
,
Lower Dial Hand to move to TR.

B + *> @
5 6
E-38
To start an Auto Start operation
1. In the Stopwatch Mode with the elapsed time reset to all zeros, press B.
x This causes the
b
Small Minute Hand,
n
Small Hour Hand, and
m
Small Hour Hand (24-hour) to
move to the current Auto Start time.
x Press B to toggle between the normal stopwatch screen and the Auto Start time screen.
2. While the Auto Start time is indicated by the hands, press A.
x This starts the countdown from the Auto Start time.
x For information about button operations after the Auto Start starts elapsed time measurement, see
“To measure elapsed time” (page E-36) and “To measure split times” (page E-36).
Note
x To interrupt the countdown and immediately start the elapsed time operation, press A.
x You can perform all normal stopwatch button operations after the elapsed time operation starts.
x Auto Start is turned off automatically when you reset the stopwatch to all zeros after the current elapsed
time operation. However, you can recall the last Auto Start time you set by pressing B.
E-37
Auto Start
Auto Start starts a countdown from a specifi ed start time (Auto Start time), and automatically starts
elapsed time measurement when the countdown reaches zero.
To set the Auto Start Time
x You can specify an Auto Start time within the range of 0 to 119 minutes and 59 seconds.
1. In the Stopwatch Mode, pull out the crown to the fi rst click.
x If you do not perform any operation with the crown for about two minutes after pulling it out, crown
operations will become disabled and the watch hands will no longer move when you rotate the
crown. If this happens, push the crown back in and then pull it out again.
2. Rotate the crown to specify the Auto Start time seconds setting.
b
b Small Minute Hand: Auto Start seconds
n
n Small Hour Hand: Auto Start minutes (0 to 60)
m
m Small Hour Hand (24-hour): Auto Start minutes (0 to 119)
x You can use high-speed movement (page E-3) when performing the above
step.
x Changing the seconds setting will also cause the minutes setting to
change.
3. Press C.
4. Rotate the crown to specify the Auto Start time minutes setting.
x You can use high-speed movement (page E-3) when performing the above
step.
5. Push the crown back in.

*
5 6
E-36
To measure elapsed time
A
A B
Start Stop Reset
x Pressing A to restart the stopwatch without resetting it will resume the elapsed time operation from
where it was last stopped.
To measure split times
A
B
Display of normal
measurement returns after
5 seconds.
A B
Start Split Stop Reset
x Pressing B again while a split time is indicated will cause the hands to jump to a new (current) split
time.
x Pressing A while a split time is indicated will stop the elapsed time operation, causing the hands to
jump to the stop time.
Note
x The Stopwatch Mode can indicate elapsed time up to 1 hour, 59 minutes, 59.95 seconds. Elapsed time
measurement will stop automatically when the maximum time is reached.
x The display illustration on page E-35 shows a stopwatch reading of 20 minutes, 45.10 seconds.
x Pressing B will not perform a reset operation while the hands are moving to elapsed timekeeping after
you enter the Stopwatch Mode.
x The
,
Lower Dial Hand indicates the 1/20 (0.05)-second count for the fi rst 30 seconds of a stopwatch
elapsed time operation. The
x
Second Hand will jump to the current value whenever A (Stop) is
pressed.
E-35
Using the Stopwatch
The stopwatch measures elapsed time and split times.
Hand Functions
z
z Hour Hand
x
x Second Hand
c
c Minute Hand
v
v Hour Hand (24-hour)
b
b Small Minute Hand: Indicates the stopwatch seconds count.
n
n Small Hour Hand: Indicates the stopwatch minute count
(1 revolution = 60 minutes).
m
m Small Hour Hand (24-hour): Indicates the stopwatch minute count
(1 revolution = 120 minutes).
,
, Lower Dial Hand: Indicates the 1/20 (0.05)-second count during stopwatch
operation.
To enter the Stopwatch Mode
Refer to the Mode Reference Guide (page E-21).
x Entering the Stopwatch Mode will cause the
,
Lower Dial Hand to move to 0.

B + 6> @
5 *
E-34
Swapping your Home City and World Time City
You can use the procedure below to swap your Home City and World Time City. This capability can come
in handy when you frequently travel between two locations in different time zones.
The following example shows what happens when the Home City and World
Time City are swapped while the Home City originally is TOKYO (TYO) and
the World Time City is NEW YORK (NYC).
Home City World Time City
Before swapping
TOKYO (TYO)
10:08 p.m.
(Standard time)
NEW YORK (NYC)
9:08 a.m.
(Daylight saving time)
After swapping
NEW YORK (NYC)
9:08 a.m.
(Daylight saving time)
TOKYO (TYO)
10:08 p.m.
(Standard time)
To swap your Home City and World Time City
Hold down A for about three seconds.
x This will make the World Time City (NEW YORK in this example) your new Home City. At the same
time, it will change your previous Home City to your new World Time City.
x The x
x
Second Hand will point to the new Home City (NEW YORK in this example) for about one
second.
Note
x If your current World Time City supports time calibration signal reception, making it your Home City
enables calibration signal reception for that city.

@
E-33
2. Rotate the crown to move the
x
Second Hand to the city code you want to select as the World Time
City.
x Each time you select a city code, the
b
Small Minute Hand,
n
Small Hour Hand, and
m
Small Hour
Hand (24-hour) move to the current time. For details about city codes, see the “City Code Table” at
the back of this manual.
x Whenever you move the
x
Second Hand to 12 o’clock while selecting a city code, it will
automatically perform one full revolution and stop at 12 o’clock from the opposite direction.
x If you think that the time indicated for the selected World Time City is not correct, it probably means
that there is something wrong with your Home City settings. Use the procedure under “To confi gure
Home City settings” (page E-24) to correct the Home City settings.
3. Hold down A for about one second to cycle through the summer time settings as shown below.
x Selecting AT (AUTO) enables automatic switching between standard time and summer time. For
details about the AT (AUTO), STD and DST settings, see “STD/DST Switching” (page E-26).
AA
AT (AUTO) STD DST
A
4. Push the crown back in.
E-32
Checking the Current Time in a Different Time Zone
You can specify one other city from the watch’s 29 time zones as your World Time City. After you do, the
watch will indicate the current time in that city. The currently selected city is called the “World Time City”.
Hands and Indicators
The hands below indicate the current time in the World Time City.
b
b Small Minute Hand
n
n Small Hour Hand
m
m Small Hour Hand (24-hour)
To enter the Dual Time Mode
Refer to the Mode Reference Guide (page E-21).
x Entering the Dual Time Mode will cause the
,
Lower Dial Hand to
move to the current day of the week (SU/MO/TU/WE/TH/FR/SA).
To view the time in another time zone
1. In the Dual Time Mode, pull out the crown to the fi rst click.
x The
x
Second Hand points to the currently selected World Time city code.
x The
,
Lower Dial Hand will indicate AT (AUTO), STD (standard time) or DST (daylight saving time),
which indicates the current daylight saving time setting.
x Leaving the crown pulled out for more than two minutes without performing any operation will
automatically cause crown operations to become disabled. If this happens, press the crown back in,
pull it out, and then start the operation over again.

*6@
5
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5369 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5369 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5369

Casio 5369 User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info