624488
7
Zoom out
Zoom in
Previous page
1/8
Next page
Operation Guide 5369 (MTG)
E-55
Power Supply: Solar panel and one rechargeable battery
Approximate battery operating time: 5 months (no exposure to light after a full charge; one signal
reception of approximately 4 minutes, and 10 seconds of alarm operation per day)
E-54
Specifi cations
Accuracy at normal temperature: ±15 seconds a month (with no signal calibration)
Timekeeping : Hour, minutes, seconds, 24-hour, day, day of the week
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: Home City and World Time City can be assigned one of 29 city codes (29 time zones) and
Coordinated Universal Time; Daylight Saving Time (summer time)/Standard Time auto switching
Time Calibration Signal Reception: Auto receive up to six times a day (5 times a day for the Chinese
calibration signal; Remaining auto receives cancelled as soon as one is successful);
Manual receive
Receivable Time Calibration Signals:
Mainfl ingen, Germany (Call Sign: DCF77, Frequency: 77.5 kHz); Anthorn, England
(Call Sign: MSF, Frequency: 60.0 kHz); Fukushima, Japan (Call Sign: JJY, Frequency:
40.0 kHz); Fukuoka/Saga, Japan (Call Sign: JJY, Frequency: 60.0 kHz); Fort Collins,
Colorado, the United States (Call Sign: WWVB, Frequency: 60.0 kHz); Shangqiu City,
Henan Province, China (Call Sign: BPC, Frequency: 68.5 kHz)
Stopwatch: Measuring capacity: 1:59'59.95"
Measuring unit: 1/20 (0.05) seconds
Measuring modes: Elapsed time, Split time
Other: Auto-Start
Countdown Timer:
Measuring unit: 1 second
Input range: 1 to 120 minutes (1-minute increments)
Alarm: Daily alarm
Other: Power Saving; Low battery alert; Auto Correction of Hand Home Positions
E-53
Signal reception is being performed successfully, but the time and/or day is wrong.
Possible Cause Remedy Page
Your Home City setting is wrong.
Check your Home City setting and correct it, if
necessary.
E-14
E-24
The watch may have been exposed to magnetism
or strong impact, which has caused problems with
proper hand and day alignment.
Adjust the watch’s hand and day home positions. E-45
Alarm
The alarm does not sound.
Possible Cause Remedy Page
Battery power is low.
Expose the watch to light until battery power is
back to normal.
E-10
The watch is in the sleep state. Move the watch to a well-lit area or press any button. E-13
The crown is pulled out. Push the crown back in. E-3
Crown Operation
Nothing happens when I rotate the crown.
Possible Cause Remedy Page
The crown has been left pulled out for more than
two minutes (30 minutes in the case of hand home
position adjustment) without any operation being
performed.
Push the crown back in and then pull it out again to
restore normal operation.
E-3
E-52
The current time setting is off by one hour.
Possible Cause Remedy Page
The period when summer time is applied in the
location where you are using the watch may be
different from the period set for your currently
selected Home City.
Use the procedure under “To switch between
standard time and summer time manually” to switch
from AT (AUTO) to STD (for standard time) or DST
(for summer time).
E-27
Auto Receive is not performed or I cannot perform Manual Receive.
Possible Cause Remedy Page
Your Home City setting is wrong.
Check your Home City setting and correct it, if
necessary.
E-14
E-24
Auto Receive is disabled because there is an
ongoing elapsed time operation or Auto Start
countdown operation in the Stopwatch Mode.
Stop the ongoing Stopwatch Mode operation. E-35
A countdown timer operation is in progress.
Both Auto Receive and Manual Receive are
disabled while a countdown is in progress. If you
want to perform Auto Receive, go to the Countdown
Timer Mode, stop the timer operation, and then
return to the Dual Time Mode.
E-39
The Auto Receive function is turned off. Turn on Auto Receive. E-19
The crown is pulled out. Push the crown back in. E-3
There is not enough power for signal reception. Expose the watch to light to charge it. E-10
E-51
Time Calibration Signal
The information in this section applies only when LONDON (LON), PARIS (PAR), ATHENS (ATH),
HONOLULU (HNL), ANCHORAGE (ANC), LOS ANGELES (LAX), DENVER (DEN), CHICAGO (CHI),
NEW YORK (NYC), HONG KONG (HKG), or TOKYO (TYO) is selected as the Home City. You need to
adjust the current time manually when any other city is selected as the Home City.
The
x
Second Hand indicates N (NO) when I check the result of the latest receive operation.
Possible Cause Remedy Page
x You are wearing or moving the watch, or
performing a button operation during the signal
receive operation.
x The watch is in an area with poor reception
conditions.
Keep the watch in an area where reception
conditions are good while the signal receive
operation is being performed.
E-16
An alarm sounded while time signal reception was
in progress.
Try again later.
You are in an area where signal reception is not
possible for some reason.
See “Approximate Reception Ranges”. E-15
The calibration signal is not being transmitted for
some reason.
x Check the website of the organization that
maintains the time calibration signal in your area
for information about its down times.
x Try again later.
The current time setting changes after I set it manually.
You may have the watch confi gured for Auto Receive of the time calibration signal (page E-17), which will
cause the time to be adjusted automatically according to your currently selected Home City. If this results
in the wrong time setting, check your Home City setting and correct it, if necessary (page E-24).
E-50
The current time setting is off by one hour.
x If you are using the watch in an area where time calibration signal reception is possible, see “To
confi gure Home City settings” (page E-24).
x The period when summer time is applied in the location where you are using the watch may be
different from the period set for your currently selected Home City. Use the procedure under “To switch
between standard time and summer time manually” (page E-27) to switch from AT (AUTO) to STD (for
standard time) or DST (for summer time).
The hands and/or day indications are off.
This could indicate that the watch has been exposed to magnetism or strong impact, which has caused
problems with proper hand and day alignment. Adjust the watch’s hand and day home position alignment
(page E-45).
Data indication is correct, but it is not in the middle of the day indicator.
The
.
Day Indicator will change gradually between approximately 10 p.m. and 2 a.m. each day. If the
date is misaligned during this period, it is only momentarily and does not indicate malfunction. If you
change your Home City setting while the current time in the new Home City is between approximately
10 p.m. and 2 a.m., the date may become misaligned momentarily.
Charging
The watch does not resume operation after I expose it to light.
It can take quite a long time to charge the battery after the power level drops to Level 3 (page E-11). Continue
exposing the watch to light until the
x
Second Hand starts moving normally (at one-second intervals).
The
x
Second Hand starts to move at one-second intervals, but then suddenly returns to moving
at two-second intervals.
The watch probably is not suffi ciently charged yet. Continue keeping it exposed to light.
E-49
Troubleshooting
Hand Movement and Position
I lost track of what mode the watch is in.
Refer to “Mode Reference Guide” (page E-21). To return directly to the Dual Time Mode, hold down C for at
least two seconds.
The
x
Second Hand is moving at two-second intervals.
All the watch’s hands are stopped at 12 o’clock and none of the buttons work (
x
Second Hand
stopped at 57, 58, 59, or 00).
Power may be low. Expose the watch to light until the
x
Second Hand starts moving normally, at one-
second intervals (page E-11).
The hands of the watch suddenly start moving at high speed, even when I do not perform any
operation.
This could be due to any one of the following causes. In all cases, the hand movement does not indicate
malfunction, and should stop shortly.
x The watch is recovering from a sleep state (page E-13).
x The time setting is being adjusted following a successful auto time calibration signal receive operation
(page E-14).
Hands suddenly stop moving. Button operation also is disabled.
The watch may be in the power recovery mode (page E-12). Do not perform any operation until the hands
return to their normal positions. The hands should return to their correct positions when normal operation
returns. To help power recover, leave the watch in a location where it is exposed to light.
The current time setting is off by hours.
x Your Home City setting may be wrong. Check your Home City setting and correct it, if necessary (page
E-24).
E-48
4. Press C.
x Check if the
b
Small Minute Hand is stopped at 12 o’clock.
x If the position of the
b
Small Minute Hand is not correct, rotate
the crown to adjust it to 12 o’clock.
5. Press C.
x Check if the
n
Small Hour Hand is stopped at 12 o’clock.
x If the position of the
n
Small Hour Hand is not correct, rotate
the crown to adjust it to 12 o’clock.
x The
m
Small Hour Hand (24-hour) moves simultaneously with
the
n
Small Hour Hand. If the hands are not at 12 o’clock,
advance the
n
Small Hour Hand until they do.
6. Press C.
x Check if the
,
Lower Dial Hand is stopped at 12 o’clock.
x If the position of the
,
Lower Dial Hand is not correct, rotate the
crown to adjust it to 12 o’clock.
7. Push the crown back in.
This exits the adjustment mode and returns to normal timekeeping.
Important!
x Leaving the crown pulled out for more than approximately 30 minutes without performing any operation
will automatically cause the adjustment operation to become disabled. If this happens, push the crown
back in and then pull it out to restart the above procedure from the beginning.
x Pushing the crown in will return to the mode you started from in step 1 with the hands and/or day in
their newly adjusted positions.

B +
*
5 6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5369 - MTG-S1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5369 - MTG-S1000 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5369 - MTG-S1000

Casio 5369 - MTG-S1000 User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info