2.Set the day by rotating the crown away from you (in the
direction indicated by the arrow in the illustration).
3.Push the crown back in to the normal position.
•Avoid changing the date setting while the current time is
between 9:00 p.m. and 1:00 a.m.
To set the day of the week
1.Pull the crown out to the first click.
2.Set the day of the week by rotating the crown towards you
(in the direction indicated by the arrow in the illustration).
3.Push the crown back in to the normal position.
•Avoid changing the day of the week setting while the current
time is between 11:00 p.m. and 2:00 a.m.
Using the Stopwatch
The stopwatch lets you measure elapsed time up to 29 minutes, 59 seconds.
To measure elapsed time
1.Press A to start the stopwatch.
2.Press A to stop the stopwatch.
•You can resume the measurement operation by pressing A again.
3.Check the elapsed time.
•The example below shows an elapsed time of two minutes, 25 seconds.
•Press B to reset the stopwatch.
This will enter the Timekeeping Mode.
Notes:
•Do not try to perform stopwatch operations while the crown is pulled out either to
the first or second click. If you try to press a button, you might accidentally cause
the crown to rotate and change the current time or day setting.
•Perform the following procedure if the stopwatch minute hand and/or second hand
do not return to their proper positions when you press B to reset the stopwatch.
To adjust the positions of the stopwatch hands
1.Press B to reset the stopwatch, and check the alignment of the stopwatch minute
hand and second hand.
2.Pull out the crown to the second click.
3.Press A to move the stopwatch minute hand and second hand.
•Use A to advance the stopwatch second hand by one second. Holding down A
will advance the hand at high speed.
•To return the stopwatch minute hand to the proper position, press B.
4.After making the adjustments you want, push the crown back in to its normal position.
•Note that pulling the crown out also stops the timekeeping second hand. After
performing the above procedure, you should also adjust the timekeeping setting.
To set the time
1.Pull the crown out to the second
click when the second hand
stops.
2.Set the hands by rotating the
crown. Rotate the crown to
move the hands clockwise.
Move the minute hand four or
five minutes past the time you
want to set, and then back it up
to the proper setting.
•Carefully set the time, making
sure to distinguish between
AM and PM.
3.Push the crown back in to the
normal position to restart
timekeeping.
■For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the mark with the
minute hand.
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
•Some water resistant models are equipped with a screw lock
crown.
•With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
•Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Specifications
Accuracy at normal temperature:± 20 seconds a month
Display:3 analog hands (timekeeping hour, minutes, and stopwatch seconds),
3 dials (timekeeping seconds, stopwatch minutes, and day of the week), day
Stopwatch function:Measuring capacity: 29'59''/Measuring unit: 1 second
Measuring mode: Elapsed time
Battery: One silver oxide battery (Type: SR626SW)
Approximately 2 years on type
SR626SW
(assuming one stopwatch operation 60 min./day)
50
40
30
20
10
Elapsed time bezel
Stopwatch second hand [25 seconds]
Stopwatch minute hand [2 minutes]
Stopwatch second hand
Stopwatch minute hand
Minute hand
Da
y
of the week
Hour hand
First click
(Setting day and
day of the week)
Second click
(Setting time)
Crown
(Normal position)
Day
Second hand
•The configuration of your watch may differ somewhat from that shown in the illustration.
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Casio 5138 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Casio 5138 in the language / languages: English as an attachment in your email.
The manual is 0,14 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
