587694
40
Zoom out
Zoom in
Previous page
1/44
Next page
40
Crankcase heater (optional on MC models).
It is advisable to switch on the crankcase
heater at least one hour before the
seasonal start-up or after long shutdown
periods.
During the whole operating season, the
power supply must always be connected;
it can only be disconnected during
shutdown periods.
Compressor winding protection
With automatic reset. It operates when the
winding temperature or power input of the
compressor exceeds the operating limits. It
can be controlled by using an Ohmmeter or
a continuity tester.
Control and security
devices
ATTENTION:
Before starting any servicing or
maintenance operation on the unit, make
sure that the power supply has been
disconnected. Electrical discharge could
cause personal injury.
In order to obtain optimum performance
from your unit and prevent possible failures,
please pay special attention to the following
points:
Outdoor coil. Prevent the accumulation
of dust and particles which may obstruct
the air flow. Clean the coil at least once a
year with a non-metallic brush, or with a
jet of pressurized air.
Electrical connections. Pay special
attention to the supply voltage (see
nameplate).
Ensure that there are no faulty contacts at
the connection blocks caused by rust, dirt
or loose screws. Check at least once a
year.
Drains. Ensure that the drain pipes are
not obstructed, and that the condensate
pan is clean. Check at least once a year.
Maintenance and
service
Riscaldatore del carter (fornito in optional
per i modelli MC)
È consigliabile alimentare il riscaldatore
del carter almeno un’ora prima del
funzionamento stagionale o dopo lunghi
periodi di non funzionamento
Durante l’intero periodo di funzionamento,
l’alimentazione deve essere sempre
fornita; si può togliere solo nei periodi di
inattività
Protezione degli avvolgimenti del
compressore
A ripristino automatico. Interviene quando
la temperatura degli avvolgimenti o
l’assorbimento elettrico del compressore
supera i limiti di funzionamento. Può essere
controllato usando un Ohmmetro o un
tester di continuità.
Dispositivi di controllo
e sicurezza
ATTENZIONE:
prima di iniziare qualunque operazione
di servizio o manutenzione sullunità,
assicurarsi che lalimentazione sia stata
scollegata. Una scossa può causare
danni alle persone
Per ottenere un’ottima prestazione dall’uni-
tà e prevenire possibili guasti, si consiglia di
prestare particolare attenzione ai seguenti
punti:
Batteria esterna. Evitare gli accumuli di
polvere e particelle che possono ostruire
il passaggio dell’aria. Pulire la batteria
almeno una volta all’anno con una
spazzola non metallica o con un getto
d’aria pressurizzata.
Connessioni elettriche. Fare attenzione
al valore della tensione di alimentazione.
Assicurarsi che non ci siano falsi contatti
nei morsetti di connessione causati da viti
allentate, sporco, ruggine o corpi estranei.
Controllare almeno una volta all’anno.
Drenaggio. Assicurarsi che i tubi di
drenaggio non siano ostruiti e che la
bacinella scarico condensa non sia
ostruita. Controllare almeno una volta
all’anno.
Manutenzione e cura
Support mounting leg
• Head pressure controller
• Crankcase heater (only 38MC and
38MCJ 334)
Options
Piastra di supporto a muro
• Controllo pressione di condensazione
• Riscaldatore del carter (solo 38MC e
38MCJ 334)
Opzioni
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrier 38MCJ 334 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrier 38MCJ 334 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info