Manual Carmen NC2007 - Perfect Nail (page 10 of 13) (English, German, Dutch, French)

570141

Zoom out

Zoom in

1/13

sunlight, humidity (never dip it into any liquid) and sharp edges.

Do not use the appliance with wet hands. If the appliance is

humid or wet, unplug it immediately. Do not put it in water.

• When cleaning or putting it away, switch off the appliance and

always pull out the plug from the socket (pull on the plug, not

the cable) if the appliance is not being used and remove the

attached accessories.

• Never leave the appliance unsupervised. To protect children from

the dangers posed by electrical appliances, make sure that the

cable is hanging low and that children do not have access to the

appliance.

• Check the appliance and the cable for damage on a regular

basis. Do not use the appliance if it is damaged.

• Do not try to repair the appliance on your own. Always contact

an authorized technician. To avoid the exposure to danger,

always have a faulty cable be replaced only by the manufactu-

rer, by our customer service or by a qualied person and with a

cable of the same type.

• Use only original spare parts.

• Pay careful attention to following special safety instruction.

• Only specialists are allowed to do reparations. Improperly

reparations can cause considerable danger!

• There is always risk of injury when using electrical appliances

improperly!

• To prevent unintentional misuse, keep the appliance stored away

in a safe place.

Special safety notes

• This unit is only suitable for ling and polishing ngernails,

toenails, corns and dead skin.

• Do not use this appliance for more than 20 minutes at a time.

If using the appliance again let it cool for 15 minutes.

Operating›instructions››

Electronic IC Control Advantage

This professional electronic IC control manicure/pedicure set is

super strong. User needs to always start with the lowest speed.

After being familiar with the machine power, then use the step

less innite speed control switch by press “+” (increasing speed)

or “-“ (decreasing speed) to select the best desired speed for

the best performance. Such innite speed control provides a wide

range of speed to suit your need. It helps to achieve a perfect

performance of this manicure/pedicure set by setting the nest

speed as you like.

How to use

At home:

1) Plug the adaptor into the mains.

2) Insert the plug of the adaptor to the jack of main unit at the end.

3) Choose the desired attachment and push into the front of

the main unit. To remove, rmly pull from the base of the

attachment. Select the desired rotation direction by pressing

the “bi-directional rotation control switch”. The “directional

rotation indicator” will light up. Green for clockwise and red for

anti-clockwise.

Remark: This bi-directional rotation feature is for enhance a

perfect and complete manicure/pedicure performance.

4) Select the desired attachment and then plug into the front head

of the machine by gripping the plastic part of the attachment.

5) Start the treatment by selecting the high or low speed by

pushing the “innite speed control buttons” “+” stand for

increasing speed and “-“ stand for decreasing speed.

6) The speed control is innite and is very strong. It provides a

very wide range of speed selection for your particular detail

manicure/pedicure purpose. Start with low speed until you

are familiar with the machine speed and application. Usually,

low speed is for nger or toe nail. High speed is for thick corn

or dead skin.

Remark: This step less control feature is super and convenient

for user to select the best speed to achieve the manicure/

pedicure function.

7) For better performance and results, do not wash your hands or

feet before treatment. Wash after treatment and massage in a

moisturizer to care and soothe your skin.

The Manicure and Pedicure Centre comes with 7 interchangeable

attachments for professional care at home:

A) The ne and rough grain sapphire cone is ideal for removal of

corns. Press gently against the thick corn and dead skin to be

treated. The ne grain sapphire cone is for at skin area. The

rough grain sapphire cone is for high heel area or any round area.

B) With the thick and thin sharp sapphire point, you can remove

hard skin as well as grind in-grown corners of nails. The

sapphire emery removes only the hard, dead skin, but glides

over the soft skin without harming it. Warning: Do not touch

the surface of the nail.

C) With the ne and rough sapphire shaping disk, the nails can be

shaped in any way you wish. Ten times faster than with a nail

le. The narrow protection-rim prevents injuries, but even so

the corners of the nails are easily accessible. Always start with

low speed rst.

18 • English

19 • English

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Carmen NC2007 - Perfect Nail in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,47 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Carmen NC2007 - Perfect Nail Manual

Product: