621065
24
Zoom out
Zoom in
Previous page
1/25
Next page
47
CHAPTER 15
EN
FAULT
NOTE:
THE MACHINE IS FITTED WITH A SPECIAL ELECTRONIC DEVICE, WHICH PREVENTS THE SPIN CYCLE
SHOULD THE LOAD BE UNBALANCED.
THIS REDUCES THE NOISE AND VIBRATION IN THE MACHINE AND SO PROLONGS THE LIFE OF YOUR
MACHINE.
If the fault should persist, contact a Candy Technical Assistance Centre.For prompt servicing, give the model of
the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the
guarantee certificate.
Important
1 The use of environment friendly detersives without phosphates may produce the following effects:
- The discharge rinse water may result cloudier due to the presence of zeolites in suspension. This does not
compromise the efficiency of the rinses.
- The presence of white powder (zeolites) on the washing at the end of the washing cycle. This does not
remain incorporated in the fabric and does not alter the colour.
- The presence of foam in the last rinse water which is not necessarily a sign of inadequate rinsing.
- The non-ionic surface-active agents present in the composition of washing machine detersives are often
difficult to remove from the washing itself and, even in small quantities, may produce visible signs of the
formation of foam.
- Carrying out further rinses, in cases such as this, is not useful.
2 If your washing machine fails to function, carry out the above-mentioned checks before calling the Candy
Technical Assistance Service.
1. Does not function
on any
programme
2. Does not load
water
3. Does not discharge
water
4. Water on floor
around washing
machine
5. Does not spin
6. Strong vibrations
during spin
Mains plug not plugged in
Mains switch not on
No power
Electric circuit fuses failure
Load door open
See cause 1
Inlet tap turned off
Timer not set correctly
Discharge tube bent
Leak from the washer between the tap
and inlet tube
The washing machine has not
discharged water
“No spin” setting (some models only)
Washing machine not perfectly level
Transport bracket not removed
Washing load not evenly distributed
Insert plug
Turn on mains switch
Check
Check
Close load door
Check
Turn on water inlet tap
Set timer on correct position
Straighten discharge tube
Replace washer and tighten the tube
on the tap
Wait a few minutes until the machine
discharges water
Turn the programme dial onto spin
setting
Adjust special feet
Remove transport bracket
Distribute the washing evenly
CAUSE
REMEDY
Advisory note
During drying phase the drum will accelerate to a higher speed to distribute the load and to
optimize the drying performance
46
CHAPITRE 15
ANOMALIE
Si le mauvais fonctionnement persiste, adressez-vous au Centre d’Assistance Technique Candy; communiquez
le nom du modèle indiqué sur la plaquette se trouvant sur la carrosserie à l’intérieur du hublot ou sur le bulletin
de garantie.
En indiquant ces informations vous obtiendrez une intervention plus rapide et efficace.
1 L’utilisation des produits écologiques sans phosphates peut produire les effets suivants:
- L’eau de vidange du rinçage est trouble à cause de zéolites en suspension; l’efficacité du rinçage n’est
absolument pas compromis;
- Présence de poudre blanche (zéolites) sur le linge à la fin du lavage: cette poudre ne pénètre pas dans le
tissu et n’en altère pas la couleur;
- présence de mousse dans l’eau du dernier rinçage: elle ne signifie pas pour autant un mauvais rinçage;
- Les tensioactifs anioniques de la formule des produits pour machines à laver, s’enlèvent difficilement du linge
et, même en toute petite quantité, ils peuvent provoquer d’importants phénomènes de formation de mousse;
- L’exécution d’autres cycles de rinçage, en de tels cas, n’apporte aucun avantage.
2 Avant d’appeler le Centre d’Assistance technique Candy, si votre machine ne fonctionne pas, effectuer les
contrôles susmentionnés.
NOTE:
LA MACHINE EST DOTEE D’UN DISPOSITIF ELECTRONIQUE QUI EMPECHE LE DÉPART DE
L’ESSORAGE SI LES CHARGES SONT MAL REPARTIES ET LIMITE LES VIBRATIONS ET LE BRUIT DURANT
LE LAVAGE.
1. Aucun
fonctionnement
sur n’importe quel
programme
2. Absence
d’alimentation
d’eau
3. L’eau n’est pas
évacuèe
4. Présence d’eau sur
le sol tout autour
de la machine
5. La machine
n’essore pas
6. De fortes vibrations
pendant la phase
de centrifugation
La fiche n’est pas introduite dans la
prise de courant
L’interrupteur géneral n’est pas branché
L’énergie électrique est coupée
Les valves de l’installation électrique
sont défectueuses
Portillon ouvert
Voir cause 1
Robinet de l’eau fermé
Programmateur mal positionné
Tuyau de vidange plié
Fuite du joint se trouvant entre le robinet
et le tuyau de remplissage
La machine n’a pas encore évacué
l’eau
La fonction “suppression d’essorage” est
introduite (exclusivement sur certains
modèles)
La machine n’est pas à niveau
Les étriers de transport n’ont pas été
enlevés
La charge de linge n’est pas répartie
de façon uniforme
Brancher la fiche
Brancher l’interrupteur général
Contróler
Contróler
Fermer le portillon
Contróler
Ouvrir le robinet d’alimentation d’eau
Positionner correctement le timer
Redresser le tuyau de vidange
Remplacer le joint et serrer à fond le
tube sur le robinet
Attendre quelques minutes et la
machine évacuera l’eau
Relever la touche “exclusion
centrifugation”
Régler les pieds
Enlever les étriers de transport
Répartir le linge de façon uniforme
CAUSE
REMEDE
FR
Note d’information
Pendant la phase de séchage, le tambour effectue des rotations à grande vitesse pour brasser
le linge et ainsi optimiser le cycle.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy CDB 465 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy CDB 465 in the language / languages: English, French as an attachment in your email.

The manual is 2,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info