Manual Cambridge Audio Minx Xi (page 7 of 20) (English)

577809

Zoom out

Zoom in

1/20

USB

Use to connect a USB storage device or another portable device containing music

les. 500mA maximum current consumption.

Standby/On

When powering up from standby the Standby/On LED will ash approximately once

a second as the unit boots up, the display will initially be blank before 'Starting…'

appears.

Note: The startup sequence can take approximately 30 seconds to complete.

Idle mode

To enable Idle mode, it must rst be activated within the setup menus. Go to

“Settings -> Idle Mode” and set to “On”.

Idle mode, when enabled, allows Minx Xi to enter a lower power suspended state

using the Standby/On button. The display is turned off and many of the internal

processes and circuits are disabled to reduce power consumption. However the

difference between Idle and Standby is that in Idle mode, power remains connected

to the main controller, Ethernet and Wi-Fi sections.

In Idle mode, networking functionality remains alive in the background. This means

that Minx Xi can be quickly woken up out of the suspended state into an operational

state using not only the front panel, the infra-red remote and the control bus, but

also the iOS app running on the iPhone or iPad. This is not possible when the unit

is in full Standby mode.

Short presses of the Standby/On button then toggle the Minx Xi between On and

Idle.

Note: after putting the unit into Idle mode, you will not be able to wake the unit into

full On mode until 5 seconds have elapsed.

Full standby can still be activated by keeping the Standby/On button pressed for

more than two seconds. A subsequent press of Standby/On turns the unit fully on,

but remember that this can not be done over the network (i.e. from the iOS app)

and that it takes longer to reach the full operational state.

Phones

Allows for the connection of stereo headphones with a 3.5mm jack plug.

Headphones with an impedance of between 32 and 600 ohms are recommended.

Note: Plugging in headphones will automatically mute the loudspeaker output.

Infrared sensor

Receive IR commands from the supplied remote control. A clear unobstructed line

of sight between the remote control and the sensor is required.

(Memory)

Press to access the Memory features for preset recall and storage.

The Minx Xi can store up to 20 Presets which can be Internet Radio stations,

Streams from Streaming Services or your own choice of Internet Radio URL. See

later section.

(Reply)

This is the reply/interactive button. Press when listening to an Internet Radio

station or Streaming Service that has some form of interaction with the user.

This function will bring up an interactive menu (where available). This feature is

commonly used allow indication that you like or don't like the current stream so the

service can tailor the music served to your personal taste.

For Media playback (UPnP or Local) this button will toggle between the 'Now

Playing' display and the current media browsing display.

Play/Pause

Plays and pauses playback.

Stop/Delete

Press during playback to stop or press in various menus to delete the present item.

Display

Displays the status of the unit.

(info)

Toggles between the 'Now Playing' and current media browsing display.

Return/Home

Press to return to the previous menu. Press and hold to go directly to the top Home

menu.

Skip

Press once to skip forwards or backwards one track.

Volume Control / Menu navigation and select

Rotate whilst the now playing display is active to adjust volume.

Pressing Home, Back or Info will switch to menu navigation. In menu navigation

rotate the control to move between various items and press the control in to select

the highlighted item.

MP3 Input

This source input allows you to connect a portable audio device such as an MP3

player directly into the front of the unit using the 3.5mm stereo-jack (labelled

'MP3'). Select the MP3 input source through the main menu 'Audio Inputs' or direct

MP3 button on the remote to listen to your portable audio device.

2 3

9 13

Front panel controls

ENGLISH

I have been using the Cambridge Audio Minx Xi for a few years now. The most recent firmware update has been done successfully. Now I am having issues with song display on the radio stations I am using. The designated radio stations are showing in the display screen, however, the message is" Station unavailable". This ist only for the stations in Germany SWR1 Baden-Württemberg Submitted on 1-4-2022 at 14:41
Reply Report abuse
I have been using the Cambridge Audio Minx Xi for a few years now. The most recent firmware update has been done successfully. Now I am having issues with song display on the radio stations I am using. The designated radio stations are showing in the display screen, however, a blank screen where the song playing should show. Any suggestions would be most helpful? Thanks.

Mike. Submitted on 23-3-2022 at 19:17
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Cambridge Audio Minx Xi in the language / languages: English as an attachment in your email.

The manual is 6,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cambridge Audio Minx Xi

Cambridge Audio Minx Xi User Manual - German - 20 pages

Cambridge Audio Minx Xi User Manual - Dutch - 20 pages

Cambridge Audio Minx Xi User Manual - French - 20 pages

Cambridge Audio Minx Xi User Manual - Italian - 20 pages

Cambridge Audio Minx Xi User Manual - Polish - 20 pages

Cambridge Audio Minx Xi User Manual - Swedish - 20 pages

Cambridge Audio Minx Xi User Manual - Spanish - 20 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Cambridge Audio Minx Xi Manual

Product: