Azur FM/AM tuner 9
Setting the Sleep Time
The Sleep function will turn off the 340T at a chosen time. It will also
generate a command on the Control Bus that, when connected, will turn
off a compatible Cambridge Audio Azur series amplifier (such as the
540A V2.0, 640A V2.0 and 740A).
To set the Sleep time:
1. On the remote handset, hold down the Alarm/Clock button whilst
simultaneously pressing the Standby button.
2. Press the | << >>| keys to alter the hour
3. Press Clock.
4. Press the | << >>| keys to alter the minute
5. Press Clock to finish.
Connecting the Control Bus
If it is desired to control a Cambridge Audio azur amplifier by the 340T’s
Alarm or Sleep timers, connect the two units via the orange Control Bus
sockets using the supplied orange RCA/phono lead as shown below:
340T FM/AM tuner
Custom Installation (C.I.) Use
The 340T has a Control Bus input/output that allow unmodulated remote
control commands (positive logic, TTL level) to be received electrically by
the unit and looped to another unit if desired. These control commands
are typically generated by custom installation (multi-room) systems.
The Control Bus sockets are colour coded orange and an appropriate
colour coded RCA/phono lead is provided for when this feature is used
(a plastic twist tie is also included for cable management). In addition
the 340T features direct IR/Control codes as well as toggle codes for
many of its features to simplify programming custom installation
systems. Special direct commands can be accessed on the supplied
remote control for teaching into C.I. systems as follows:
Specific power on/off commands – press and hold the Standby button.
The remote first generates it's usual amp and tuner standby (toggle)
commands (both are sent). Keep the button held down, after 12 seconds
an Amp On command will be generated, then if the button is kept held
down after a further 12 seconds an Amp off comand is generated, then
separated by 12 second pauses, Tuner On, and finally Tuner Off.
Specific band selection commands – press and hold the FM/AM key.
The usual band toggle command is first, then the FM Mode command,
followed by the AM Mode command is generated.
Specific Preset/Scan mode commands – Press and hold the Mode key.
The usual mode toggle command is first, then the Scan Mode
command, followed by the Preset Mode command.
Specific Mute On/Off commands – press and hold the Mute key. The
usual mute toggle command is first, followed by the Mute On command,
and then the Mute Off command.
A full code table for this product is available on the Cambridge Audio
website at www.cambridge-audio.com.
