165946

Caliber mcc 110 Manual

3
Zoom out
Zoom in
Previous page
1/21
Next page
NOTE:
You must use 4 ohms impedance of speaker in your speaker system to reduce the distortion
during high volume level.
INSTALLATION
1. Choose the mounting location that will not interfere the normal driving function of the driver.
2.Avoid installing the unit in a place where it would be subjected to dirt, dust, damp, high
temperature and excessive vibration.
3. Please install appendixes provided by the manufacturer.
PRECAUTIONS AND MAINTENANCE
1.This unit is designed for negative ground operation only.The equipment can be used safely,
if the negative terminal of the battery is connected to the vehicle metal work.
2.Do not use speakers of impedance less than 4 ohms; and allow the speaker wires to be
shorted together when the unit is switched on. Otherwise it may overload or burn out
the power amplifier stage.
3.If the car interior is extremely hot, as after being parked in the sun, do not use the player
until the car has been driven for a while to cool off the interior.
4.Ta ke care of your tape cassette to preserve the quality of the recordings. Do not expose
them to direct sunlight. Store them in a place protected from dirt and dust and
avoid handing with greasy or oily hands.Also, keep the away from magnets, and
motors of the permanent magnet type.
5.It is not advisable to use cassette tapes longer than C-60(30 minutes per side) in
automobile players, since the tape is too thin and tends to become easily entangled.
Always remove cartridge from your tape player as soon as play is finished.
6.The capstan and tape head should be cleaned about once every six months with a soft cloth or cot-
ton-wool swab, moistened with alcohol.
This will serve to maintain the richness and clarity of sound, and prevent loss of volume. Do not use a
screwdriver, or ferrous metal rod, in carrying out the above cleaning. See illustration.
7.A loosely wound cassette tape will get damaged. Prior to using such tape, tighten it in a manner as
guided by Fig2.A carelessly wound cassette tape will cause unnecessary pressure on the tape resul-
ting in the cassette springing out while the tape is running. For prevention, rewind the tape through
fast forwarding or rewinding.
GB 4
USER MANUAL
2).Temporary switch over to an EON linked station when EON detects a traffic announcement
on the other program.
3).If the volume level was under the threshold point, it will be raised to the threshold point. If
the volume level was set to more than the threshold point (min.TA volume level), it will be set
to the last level.
When pressed long,TA SEEK mode on or off, and TPST ON/OFF will be displayed on LCD.
When the newly tuned station does not receive TP information for 5 seconds, the radio retunes
to the next station which has not got the same station(PI) as the last station, but does have the
TP information.
In TA seek mode, the current station can be changed to a completely different station because
the unit searches TP station when the field strength of the current station is very weak, or when
the current station has no TP signal.
15.TUNE UP OR DOWN BUTTONS
In RADIO mode, press ^ or v button shortly and repeatedly to manually tune up or down for
the desired radio station. Press ^ or v button for more than 2 seconds to automatically tune up or
down for the radio station of a strong signal.
16.EJECT KEY
At TAPE mode, push this key to stop tape playing and eject the tape from the cassette compartment.
17.CASSETTE COMPARTMENT
18. MUTE
19. STEREO/MONO
SPECIFICATIONS
Power Supply Main Unit DC 13.8 Volts. Negative Ground
Current consumption 10A MAX
Maximum Output Power 35W X 4
Unit Dimensions 178(W) x 150(D) x 50(H)
FM SECTION
Frequency Range 87.5MHz - 108MHz
CAUTION: Do not install the detachable panel before connecting the unit.
1.The unit is designed for negative terminal of the battery which is connected to the vehicle
metal. Please make sure this is connected before starting installation.
2. If the car interior is extremely hot, as after being parked in the sun, do not use the player until
the car has been driven for a while to cool off the interior.
GB 3
USER MANUAL
REL
M1.TAPPING SCREW
M2. PLAIN WASHER
M3. SPRING WASHER
M4. HEX NUT
M5. HEX BOLT
M6. SLIDE BRACKET HOUSING
M7. CONSOLE
M8. DASH BOARD
M9. METAL MOUNTING STRAP
M10. KEY PLATE
2.
MCC_110manualOUTLINES 18-03-2005 11:47 Pagina 3
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Caliber mcc 110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Caliber mcc 110 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 6,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info