541605
11
Zoom out
Zoom in
Previous page
1/13
Next page
10.General Maintenance
11.Cleaning
This appliance does not require scheduled maintenance.
Your Carri Chef is fitted with a specific size jet regulate the correct amount of gas.
Should the hole in the Jet become blocked, this may result in a small flame or no flame at all. Do not attempt to clean the Jet with a pin or
other such device as this may damage the orifice, which could make the appliance unsafe.
To replace the Jet :Unscrew the fitting connected to the inlet of the valve (O) before unclipping the valve cover (P1).
After cooking, leave the burner on low with soapy water in the cooking dish to soften cooking residue. When satisfied that
excess fat has been removed, wash the Skottel BBQ (I1) in warm water using a suitable non-abrasive detergent. Do not use sharp metal
objects or abrasive detergents on the vitreous enamel coated surface.
Remove the fat from the moat at the bottom of the Fat Pan (B) and clean as described for the Skottel BBQ. Wash the Grid
(H1) and Deflector Plate (H2) in warm water with non-abrasive detergent after wiping off any excess fat left after cooking.
: Wash the BBQ Lid (A) in warm water using a suitable non-abrasive detergent. Do not use sharp metal objects or abrasive
detergents, as this will damage the surface coating.
For stubborn stains, oven cleaner may be used.
The Non-stick reversible grill plate is coated with a tough durable non-stick coating that has been used with great success on some of the
best cookware in the world. Nevertheless, taking care of it can help you to enjoy extra years of healthy, easy, non-stick cooking.
Use only low or medium heat settings to help retain the valuable nutrients in the food and maintain the non-stick surface.
Whilst the non-stick coating is very durable, it can easily be damaged by the use of metal cooking utensils. It is therefore recommended
that only plastic or wooden utensils be used when cooking.
Do not overheat the Non-stick reversible grill plate and always add a little cooking oil to the surface before use.
The non-stick coating is perfectly safe in the dishwasher, but the non-stick surface is so easy to clean that a quick hand-wash does the
trick. The use of abrasive detergents is not recommended, as this will permanently damage the non-stick surface.
After cleaning recondition the surface with a light wipe of oil.
Remove the fat from the moat of the Fat Pan (B) and clean as described for the BBQ above.
Replacing a Blocked Jet:
Note: For Parts Reference
Skottel BBQ:
BBQ:
BBQ Lid
Note:
Always allow the Non-stick reversible grill plate to cool before immersing it in water.
Use only low or medium heat settings to help retain the valuable nutrients in the food and maintain the non-stick surface.
Whilst the non-stick coating is very durable, it can easily be damaged by the use of metal cooking utensils. It is therefore recommended
that only plastic or wooden utensils be used when cooking.
Do not overheat the Paella Pan and always add a little cooking oil to the surface before use.
Paella Pan:
Always allow the Paella Pan to cool before immersing it in water.
Care of the Non-Stick Reversible Grill Plate:
(Fig, 4) to
(See Fig. 9a-c)
that because the valve inlet has a left-hand thread, unscrewing any fitting requires clockwise rotation when viewed from the
fitting end of the valve. Remove the Control Knob by first removing the indicator cover and then loosening the screw holding the knob in
place, firmly pull the knob off of the valve spindle. Remove screw holding Valve Cover (P1) and remove cover by pulling it forward, past
the spindle. Undo the two screws located inside the Burner Pan that are holding the Valve Clip Cover (P2) and remove cover. the
Valve is now exposed. remove the 2 screws holding the valve in position and remove the valve by lifting it out of the valve box. Be very
careful not to pull piezo wire too much. Holding the valve, use a suitable spanner to loosen and remove the jet. Do not use pliers on the
jet as this may damage the jet, making it unusable or impossible to remove. Screw the new jet into the valve. Do not over-tighten as this
may damage the jet.
Reverse the above procedure to re-assemble the unit
Reconnect the gas supply as described in the Assembly Instructions.
The fitting of a hose is described in Section 6 - Assembly of the Appliance.
Remember
(See Fig.2)
Replacing the Hose:
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cadac CARRI CHEF 8161 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cadac CARRI CHEF 8161 in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cadac CARRI CHEF 8161

Cadac CARRI CHEF 8161 User Manual - German - 11 pages

Cadac CARRI CHEF 8161 Manual - Dutch - 16 pages

Cadac CARRI CHEF 8161 User Manual - Dutch - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info