684180
5
Zoom out
Zoom in
Previous page
1/7
Next page
44
5. Fitting and Changing the Hose and Gas Cylinder
Before tting the regulator to a gas container, ensure that the seal on the regulator is in position and in good condition.
This should be done on every connection.
Ensure that the gas container is tted or changed outdoors, away from any source of ignition, such as naked ames or electric res and
away from other people.
Making sure that the gas container is kept upright, screw the regulator onto the gas container until it is fully engaged. Do not over tighten.
If there is a leak on your appliance (smell of gas), take immediately into a ame-free location where the leak may be detected and
stopped.
If you wish to check for leaks on your appliance, do it outside using soapy water only, which is applied to the joints. A formation of
bubbles will indicate a gas leak.
Check that all the connections are securely tted and re-check with soapy water. If you cannot rectify the gas leak, do not use the
appliance. Contact your local CADAC stockist for assistance.
When changing a gas container close the cylinder valve and then the appliance Valve (see Figs. 1 and 2). Making sure the ame is
extinguished, unscrew the regulator. Re-t a full gas container following the same precautions as described above.
Fig. 8
GB
6. Using the Appliance
This appliance must be used outdoors only!
When in use, protect from wind for optimum performance.
Do not move the unit whilst hot. The use of protective gloves is
recommended.
CAUTION: Accessible parts may become very hot. Keep young
children away from the appliance.
To pack away, let the unit cool. After cleaning,
Fold the appliance as described is section 3 above.
Fold over the lid of the bag, and zip it closed. (Fig 8)
Keep the appliance in its Carry Bag when not in use, as this will
prevent the ingress of dirt or insects which may affect the gas ow.
When attempting to light the appliance, make sure that the gas
supply from the cylinder is open prior to turning on the gas supply to
the appliance.
Using the control knob
The control knob is tted with two positive stop positions, one at
low, and one at Ignite / High. This limits the adjustment of the
ame to between these two points.
Lighting up using the Piezo Igniter
To light up the appliance using the piezo igniter, push in and turn
the control knob in an anti-clockwise direction until you hear a
click. If the gas does not ignite on the rst spark, push in, and
turn the control knob fully clockwise. Try again, by pushing in and
turning the control knob anti-clockwise until you hear a click. If the gas has not ignited in the rst two to three seconds you should
close the control valve by pushing in the control knob, and turning it fully clockwise. Wait approximately thirty seconds to let any
accumulated gas within the burner pan assembly escape. Repeat the above process if necessary until the ame ignites. The ame
should normally light up within the rst one or two seconds.
Lighting up using a BBQ lighter
When starting cold, the appliance may be lit from the top prior to tting the desired cooking surface onto the fat pan. When lighting up
a hot appliance however, it is recommended that this be done by sticking barbecue lighter through one of the Vent Holes underneath
the Burner, until it is in line with the burner (DO NOT place the BBQ lighter through the large hole directly underneath the burner).
Ignite the BBQ lighter. Whilst the BBQ lighter is lit, push in and turn the control knob anti-clockwise to light the burner.
Use the control knob to adjust the ame intensity to the desired level by turning the knob clockwise to decrease the ame and anti-
clockwise to increase the ame.
When not in use disconnect the appliance from the gas supply.
WARNING: Do not use any cooking surfaces on a high ame setting for more than 10 minutes as this can damage the non-stick
coatings.
7. Cooking Options
There are three available cooking options with your Camp Chef appliance. These are:
Grilling: This cooking option is ideal for grilling of chicken, sausages, chops, kebabs, sh or vegetables. For this type of cooking, place the
grill plate onto the pot stand.
503-0573 LEV12 (6530L0, 6530L1) Camp Chef LP - User Manual - (EU + SA).indd 4 15/08/2017 13:09:36
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cadac 6530L0 - Camp Chef LP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cadac 6530L0 - Camp Chef LP in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cadac 6530L0 - Camp Chef LP

Cadac 6530L0 - Camp Chef LP User Manual - German - 7 pages

Cadac 6530L0 - Camp Chef LP User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info