Using the template provided, drill two appropriate sized holes to
accommodate the wall plugs. When tightening the screws leave
approximately 10mm of the screw proud.
Connector Block
Terminals
Transformer Operation: Two Wire Installation (standard)
Commonly used when upgrading a previous installations:
1: Connect one of the wires (Bell Push Or Transformer) to terminal 2 of the
chime connector block.
2: Connect the second wire from the bell push to terminal 3 of the
chime connector block.
3: Test to make sure that the chime is operating correctly.
NB:The chime connector block can be adhered to the chime by
removing the sticky tab cover from the bottom of the connector block.
Transformer Operation: Four Wire Installation
Commonly used in new installations:
1: Connect one of the wires from the Bell Push to terminal 3 of the chime connector
block and the second wire to terminal 4 of the chime connector block.
1: Connect one of the wires from the Transformer to terminal 2 of the
chime connector blockand the second wire to terminal 4 of the chime
connector block.
3: Test to make sure that the chime is operating correctly.
NB: The chime connector block can be adhered to the chime by
removing the sticky tab cover from the bottom of the connector block.
Battery Layout
Wire to Bell Push &
Transformer
Battery Operation:
1: insert 4 x Size ‘C’ (LR14) batteries, take care to make sure that the battery
polarity matches the internal markings.
2: Connect one of the wires from the bell push to terminal 1 of the chimes
connector block.
3: Connect the second wire from the bell push to terminal 4 of the
chimes connector block.
4: Test to make sure that the chime is operating correctly.
NB: The chime connector block can be adhered to the chime by
removing the sticky tab cover from the bottom of the connector
block.
Wire to Bell
Push
Wire to
Bell Push
Wire to
Transformer
:V2
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Byron 62570 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Byron 62570 in the language / languages: English as an attachment in your email.
The manual is 0,27 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
