497312

Bullit DVD7200BT Manual

4
Zoom out
Zoom in
Previous page
1/48
Next page
DVD7200BT ENGLISH
- If you need to drill holes or make other changes for the installation, consult a
specialized workshop in your area.
- This device is designed for a vehicle power supply of 12 V with the ground on the car
body (negative pole). Check the battery voltage before installing it into a camping
vehicle, bus, or truck.
- To avoid short circuits, the battery has to be disconnected before the installation.
- Read the guidelines in this handbook for the connection of the power supply and
other options.
- Secure the installed cables with insulating tape, cable ties, or cable clamps. To
protect the cables from damage, use insulating tape when guiding them past metal
components. Place and secure all cables in such a manner that they are not in the
vicinity of movable parts, such as e.g. the parking brake, gas/brake/coupling pedals,
handle bars and seat tracks.
- Don’t place any cables in the vicinity of heat sources (e.g. near the heater ventilation),
since the insulation of the cables might get damaged and result in short circuits.
- Don’t short circuit any cables. This can result in damages to the vehicle and device.
- Never establish a power supply to other devices by removing the insulation of the
device’s power supply and connecting an additional cable. Otherwise, the maximum
power rating of the cable will be exceeded and there will be a danger of overheating.
- If you have to replace the fuse, only use an identical one with the same rating.
- The connected speakers have to be high-performance speakers with a minimum
output of 40 W and an impedance ranging from 4 to 8 ohm. If you connect speakers
with other output or impedance ratings, the speakers may burn, smoke, or sustain
other kinds of damage.
- When the device is turned on, a control signal adjoins the blue cable of the
connection A5 (ISO plug A). You can connect this to the relay of the extendable
vehicle antenna (max. 100 mA, 12 V=). If your vehicle has a wire antenna inside the
windshield, connect the blue cable A5 (ISO plug A) to the pre-amplifier of the
antenna.
- If an external audio amplifier is connected to the device, the blue cable of connection
A5 (ISO plug A) may not be connected to the power supply of the amplifier. Likewise,
you may not connect it to the power supply of an active car antenna. This poses a
risk of short circuits and malfunctions.
- Insulate unused connection cables with insulating tape. The same applies to unused
speaker cables. Otherwise there is a risk of short circuits.
- Dirt or condensed moisture on the lens of the CD/DVD drive may impede and even
prevent the playback of data carriers.
- In general, the playback of self-burned data carriers is possible, but it depends on the
used software and the settings made with it, so that there may be problems during
playback in individual cases. You can receive further information from the
manufacturer of your software.
- Additional CD data carriers can be played back just like audio CDs. It’s possible that
CD-R/CD-RW data carriers can’t be played back correctly if they were recorded by a
device other than an audio CD recorder.
- In addition, it may be the case that a data carrier (CD-R/CD-RW) recorded with an
audio CD recorder can’t be played back due to the conditional features, irregular
formats, or soiling of the data carriers.
- The information recorded on the data carrier (ID3TAG) is displayed by this device.
- After inserting a CD-RW data carrier, it takes a little longer for the playback to begin
than with regular CD or CD-R data carriers. Also read the guidelines on the sleeves
of the CD-R/CD-RW data carriers before you insert them.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bullit DVD7200BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bullit DVD7200BT in the language / languages: English as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info