637985
5
Zoom out
Zoom in
Previous page
1/36
Next page
5
All factory-made connections have been rigorously tested
for gas leaks. However, shipping and handling may have
loosened a gas fitting.
AS A SAFETY PRECAUTION:
Test all ttings for leaks before using your gas grill.
Test the cylinder valve for leaks each time the cylinder
is lled.
Test for leaks every time you connect a gas tting.
Do not smoke at any time while testing.
Never test for leaks with a lit match or open ame.
Test for leaks outdoors.
TO TEST FOR LEAKS:
1. Extinguish any open flame
or cigarettes in the area.
2. Be sure that cylinder valve and
gas grill valves are “OFF.”
3. Connect LP gas cylinder. See “Hose and Regulator.”
4. Prepare a soap solution of one part water, one part liquid
detergent.
5. With a full gas cylinder, open cylinder slowly.
6. Brush the soap solution on each connection.
7. A leak is identified by a flow of bubbles from the area of
the leak.
8. If a leak is detected, close the gas cylinder “shut-off” valve,
tighten the connection and retest.
9. If the leak persists, contact your gas grill dealer for
assistance. Do not attempt to operate appliance if a leak
is present.
If your gas grill is equipped with a side burner or rear
burner:
1. Follow steps 1 - 5 above
2. Place fingertip over the opening in the orifice at the end
of hose.
3. Turn “SIDE”/”REAR” control to “HIGH.”
4. Brush soap solution on each connection between orifice
and control valve.
5. Turn “SIDE”/”REAR” control to “OFF”.
Always keep venturi tubes clean. Blockages in the venturi
tubes caused by spiders, insects and nests can cause a
flashback fire. In fact, although the gas grill may still light, the
backed up gas can ignite and cause a fire around the venturi
tubes at the control panel or the side burner.
VENTURI TUBE SPIDER WEB TUBE BURNER
If a ashback re occurs, turn off gas at the source
immediately
Inspect and clean the venturi tubes (main burner, side
burner, rear burner) if any of the following symptoms
occur:
1. You smell gas.
2. Your gas grill does not reach temperature.
3. Your gas grill heats unevenly.
4. The burners make popping noises.
INSPECTING & CLEANING VENTURI
TUBES
1. Turn off gas by closing the propane cylinder valve
2. When gas grill is cool, remove the burner fasteners and
the top portion of the collector box. Proceed to lift the
burners from the gas grill housing.
3. Clean the venturi tubes with a pipe cleaner or venturi
cleaning tool (Accessory #77310 or #18270).
4. Lower the burner into position in the gas grill housing,
making sure that the venturi tubes are correctly aligned
and fitted on the orifices.
5. Secure burners with burner fasteners.
6. Snap top portion of collector box back in place.
LEAK TESTING VENTURI TUBES
5


Need help? Post your question in this forum.

Forumrules
1

Forum

broilking-signet-320

Reset search

  • My broil king grill I bought as a clearance item a couple of years ago and I have used it maybe 4times and it has a hard time starting which now it won’t even start at all what can I try Submitted on 4-7-2021 at 23:26

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BroilKing Signet 320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BroilKing Signet 320 in the language / languages: English as an attachment in your email.

The manual is 4,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BroilKing Signet 320

BroilKing Signet 320 Installation Guide - English, French, Spanish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info