562809
20
Zoom out
Zoom in
Previous page
1/21
Next page
BrightSign HD120, HD220, HD1020
17
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2012
Green flash activity Flashes any time there is CPU activity.
Yellow update Flashes when the board is being upgraded.
Red status Flashes a certain number of times to indicate which error is occurring. The flash codes are
described below.
2 Unspecified error
3 Network recovery script is preparing to run on a device configured for network recovery.
4 No upgrade file found
5 Failed to load kernel module
6 Board is not capable of running the current firmware version.
7 Problem related to the Ethernet chip
7 A piece of on-board hardware is not working correctly (on firmware versions 4.1 and later).
8 Problem related to the storage device (either the USB drive or SD card)
9 Problem related to the registry/EEPROM
10 The autorun script encountered a load/run error.
11 WiFi-related error (mainly, WiFi not found on USB)
12 Unable to find a bootable image (on firmware versions 4.0 and later)
On-Board Switch
The on-board switch is connected to the GPIO32. A pullup on the button normally sets the GPIO32 to be pulled high.
Conversely, the GPIO32 is pulled low when the button is pressed.
Reset Switch/GPIO Button
The on-board switch is connected to the GPIO12. Pressing down the reset button will cause the GPIO12 to go low.
Holding the reset button low for approximately 10 seconds will cause a hard reset. When the board goes into reset mode,
the power LED will be dark until the reset button is released.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BrightSign HD220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BrightSign HD220 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BrightSign HD220

BrightSign HD220 Quick start guide - English - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info