8859
5
Zoom out
Zoom in
Previous page
1/23
Next page
5
Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Carefully read the use instructions before use.
Important
Plug your hairdryer into an alternating current
(
Ù
) outlet only and be sure that your household
voltage corresponds to the voltage marked on
the hairdryer.
Do not allow the appliance to become
wet.
When using the hairdryer in a bathroom, always
unplug it after use. Even a switched-off hair-
dryer presents a hazard if not unplugged.
For additional protection, it is advisable to
install a residual current device (RCD) with a
rated residual operating current not exceeding
30 mA in the electrical circuit of your bath-
room. Ask your installer for advice.
Care should be taken not to block the inlet and
outlet grill when the hairdryer is switched on. If
either grill becomes blocked, the hairdryer will
automatically cut out. After cooling for a few
minutes, it will switch back on automatically.
Do not wrap the mains cord around the ap-
pliance. Regularly check the mains cord for
wear or damage, particularly where it enters the
product and the plug. If you have any doubt
about its condition take the appliance to your
nearest Braun Service Centre for checking/
repair. The mains cord of the appliance may
only be replaced by an authorised Braun
Service Centre. Unqualified repair work can
lead to extreme hazards for the user.
Description
1
Switch
2
Cold shot button
3
Long-life Filter
4
Concentrator nozzle
5
Diffusor attachment
Switch settings
1
Cold shot
2
To fix a style with cold air, press the cold shot
button.
Long-life Filter
3
Regularly wipe the filter clean. For a thorough
cleaning, remove the filter and clean it under
running water.
Concentrator nozzle
4
For precise styling use the concentrator nozzle.
Diffusor attachment
5
Attaching the diffusor
Align the notches on the rim of the diffusor
attachment with the slots in the hair dryer.
Push the attachment onto the hairdryer, then
turn clockwise until the bayonet lock clicks
into place.
•To remove the diffusor, turn in the opposite
direction and pull.
Volume styling
Short to mid-length hair:
To add volume and root lift, gently guide the
diffusor fingers with a small circular motion
over your scalp. Continue section by section.
Lon
g hair:
First dry hair ends by placing them onto the
finger plate. Then, with the diffusor, carefully lift
the hair to your head and hold. Finish off the
roots with a gentle circular movement of the
diffusor fingers on the scalp to add some lift.
Subject to change without notice.
This product conforms to the EMC-Directive
89/336/EEC and to the Low Voltage Regulation
73/23 EEC.
0 = off
1 = gentle drying
2 = fast drying
English
3514008_CPC1600DFB6 Seite 5 Montag, 20. Oktober 2003 8:43 08
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Braun 3514 CP1600 DFB6 Creation diffusor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Braun 3514 CP1600 DFB6 Creation diffusor in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info