647578
7
Zoom out
Zoom in
Previous page
1/10
Next page
8
Care and cleaning
Heat exchanger
The dryer's heat exchanger is cleaned automatically during drying.
SELF CLEANING appears
rolling in the display panel. Do not pull out the condensate container during the cleaning
process.
Dryer housing, control panel
Wipe with a soft, damp cloth.
Do not clean with a water jet.
Remove detergent and cleaning agent residue immediately.
Some water may collect between the window and the seal during drying.
This does not affect the proper operation of your dryer in any way.
Filter in the condensate container
The filter is cleaned automatically when the condensate container is emptied.
However, the filter should still be cleaned regularly under running water a This prevents
stubborn deposits/dirt from building up.
1. Pull out the condensate container.
2. Pull the filter out of its snap-in lock.
3. Clean the filter under running water or in the dishwasher.
4. Refit the filter.
5. Insert the condensate container so that it locks into place.
Only operate the dryer with the filter inserted.
Moisture sensors
The dryer is equipped with stainless steel moisture sensors.
Moisture sensors measure the moisture level of the laundry.
After sustained, repeated operation, a fine layer of limescale
may form on the moisture sensors.
1. Open the door.
2. Clean the moisture sensors with a damp sponge which has a rough
surface.
Do not use steel wool or abrasive agents!
Only when switched off!
9
Installation
Scope of delivery: dryer, operating and installation instructions, basket for woollens
(depending on the model).
Check the dryer for transport damage.
The dryer is very heavy. Do not attempt to lift it on your own.
Be careful to avoid sharp edges.
Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Do not set up in a room that is susceptible to frost. Freezing water may cause damage.
If in doubt, have the appliance connected by a specialist.
Setting up the dryer
The mains plug must always be accessible.
Ensure that the appliance is placed on a clean, level
and firm surface.
Do not obstruct the air inlet on the dryer.
Keep the area around the dryer clean.
Level the dryer using the threaded feet
and a spirit level.
Never remove the threaded feet!
For mains connection, see Safety instructions a page 13.
Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
The mains voltage and the voltage shown on the rating plate (a page 10) must be the
same.
The connected load and necessary fuse protection are specified on the rating plate.
Frost protection
Preparation
1. Empty the condensate container a page 4,8/12.
2. Select any programme using the programme selector.
3. Press the Inicio/Stop (Start/Pause) button a condensation is pumped into the container.
4. Wait several minutes or until the dryer stops, and then empty the condensate container
again.
5 Turn the programme selector to Stop.
Transport
Prepare the dryer a see Frost protection.
Transport the dryer in a vertical upright position.
Following transportation, do not use the dryer for two hours.
The dryer contains residual water; this can flow out if the dryer is tilted.
1.
Take all accessory parts out
of the drum.
The drum must be empty.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not install the dryer behind a door
or sliding door which could prevent or
obstruct the dryer door from opening.
This will prevent children from locking
themselves in and risking their lives.
2.
Do not operate the dryer if
there is a risk of frost.
ʠ
ʠ
|ü

ʠ
ʠ
a
ʠ
a
ʠ
Í a
a
a
a
a
a
ʠ
ʠ
p a
ʠ
ʠ
ʠ
a
ʠ
ʠ
ʠ
a
ʠ
ʠ
a
a
a a
a
ʠ
a
a
ʠ
ʠ
a
ʠ
a
a
a
a
a
a
a
a
a
a
a a
a
a
a
a
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WTW85202 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WTW85202 in the language / languages: English as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info