773220
2
Zoom out
Zoom in
Previous page
1/10
Next page
8
Installation
Scope of delivery: dryer, installation and operating instructions.
Check dryer for transport damage.
The dryer is very heavy. Do not attempt to lift it on your own.
Be careful to avoid sharp edges.
Do not set up in a room that is susceptible to frost. Freezing water may cause damage.
If in doubt, have the appliance connected by a specialist.
Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Setting up the dryer
The appliance plug must always be accessible.
Ensure that the appliance is installed on a clean, level
and firm surface.
Do not obstruct the air inlet on the front of the dryer.
Keep the area around the dryer clean.
Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Mains connection see Safety instructions apage 13.
Connect to an AC earthed socket. If in doubt have the
socket checked by a specialist.
The mains voltage and the voltage shown on the rating
plate (apage 10) must be the same.
The connected load and necessary fuse protection are
specified on the rating plate.
Frost protection / Transport
Frost protection - preparation
1. Empty the condensation container apage 4.
2. Select any programme using the programme selector.
3. Press the Start/Stop button a condensed water is pumped into
the container
4. Wait 5 minutes and then empty the condensation container again.
5. Turn the programme selector to Off.
Transport
Prepare the dryer a see Frost protection - preparation.
Transport the dryer in a vertical upright position.
Following transportation, do not use the dryer for two hours.
The dryer contains residual water;
this can flow out if the dryer is tilted.
Signal
Switching on/off an acoustic signal at the end of the programme
Low Heat Ď light on a"an acoustic signal at the end of the programme is switched on.
Low Heat Ď light off a an acoustic signal at the end of the programme is switched off.
1.
2.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not set up the dryer behind a door or sliding door, as this may obstruct
the dryer door or prevent it from opening. This will prevent a potentially
fatal danger to children from locking themselves in.
1 x to the
right
Press and hold Low heat Ďand turn 3 x to the right
Press Low heat Ďto
switch on/off the signal
Turn to
Off
Turn to
Off
Do not operate the dryer if
there is a danger of frost.
9
Care and cleaning
Heat exchanger
The dryer's heat exchanger is cleaned automatically during drying.
Do not pull out the condensation container during the cleaning process.
Dryer housing, control panel, air intake
Wipe with a soft, damp cloth.
Do not use harsh cleaning agents or solvents.
Remove detergent and cleaning agent residue immediately.
Filter in the condensation container
The filter is cleaned automatically when the condensation container is emptied.
However, the filter should still be cleaned regularly under running water a This prevents
stubborn deposits/dirt from building up.
1. Pull out the condensation container.
2. Pull the filter out of its snap-in lock.
3. Clean the filter under running water or in the dishwasher.
4. Refit the filter.
5. Insert the condensation container so that it locks into place.
Only operate the dryer with the filter inserted.
Moisture sensor
The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how
damp the laundry is. A thin layer of limescale may build up on the moisture sensors after
prolonged use.
1. Open the door.
2. Clean the moisture sensors using a damp sponge with a rough surface.
Do not use steel wool or abrasive materials.
Appliance must be switched off.
10
Technical data
ʠDimensions (DxWxH) 60 x 60 x 85 cm (height adjustable)
Weight approximately 51 kg
Max. capacity 7 kg
Condensation container 4.0 l
Connection voltage 220-240 V
Connected load max. 1000 W
Fuse protection 10 A
Ambient temperature 5 - 35°C
Product number
Production number under the door
The rating plate can be found on the back of the dryer.
ʠDrum interior light (depending on model) (bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb apage 12.
Consumption rates
Fabrics/programmes Residual moisture in the fabrics
after spinning Drying time** Energy
consumption**
L Cottons 7 kg
Cupboard Dry* 1400 rpm (50%) 134 min 1.75 kWh
1000 rpm (60%) 155 min 2.03 kWh
800 rpm (70%) 175 min 2.32 kWh
Iron Dry* 1400 rpm (50%) 98 min 1.24 kWh
1000 rpm (60%) 119 min 1.52 kWh
800 rpm (70%) 139 min 1.81 kWh
Easy-Care 3.5 kg
Cupboard Dry* 800 rpm (40%) 54 min 0.57 kWh
600 rpm (50%) 68 min 0.72 kWh
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes Drying time Annual energy consumption
L Cottons 7 kg / 3.5 kg*
Cupboard Dry*** 124 min / per cycle 258 kWh / per year
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
Optional accessories (from after-sales service using order number)
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened to the washing machine using this connection set.
WTZ 11300: with pull-out worktop.
Installation underneath the worktop
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
Platform
For easier loading and unloading. The basket contained in the drawer can be used
to carry the laundry.
WTZ
11310
WTZ
10290
WMZ
20500
11
Normal noises
During drying, the compressor and the pump generate some noise which is entirely normal.
The compressor in the dryer may
occasionally generate a humming noise.
The volume and pitch of this may vary
depending on the selected
programmes and the progress of the
drying.
The compressor in the dryer is ventilated
from time to time, which creates a whirring
sound.
The automatic cleaning process causes
a clicking noise.
The process of pumping the condensation
into the condensation container generates
pumping noises.
12
What to do if...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory, or by calling
one of these numbers:
GB 0844 892 8979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
IE 01450 2655
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see under the loading door).
Turn the programme selector to Off and unplug the mains plug from the socket.
ʠThe Start/Stop indicator lamp
does not light up.
Mains plug plugged in?
Programme selected?
Check the socket fuse.
ʠThe display panel light and
indicator lights (depending on
model) go out and the
Start/Stop indicator light
flashes.
Energy-saving mode is activated
a
see the separate
Energy-saving mode instructions.
ʠThe Container indicator lamp
and the Start/Stop button are
flashing.
Empty the condensation container apage 4.
Clean the condensation container filter if necessary
apage 9.
Dryer transported? a Wait 2 hours and start again.
ʠThe Clean indicator lamp and
Start/Stop button are flashing.
Rinse the fluff filter under running water apage 4.
ʠDryer does not start. Start/Stop button selected? Door closed?
Programme set? Ambient temperature greater than 5 °C?
ʠWater is leaking out. Make sure the dryer is level.
ʠThe door opens by itself. Push the door closed until you hear it click into place.
ʠCreasing. Laundry load exceeded?
Remove articles of clothing immediately after the end of the
programme, hang up and pull into shape.
Unsuitable programme selected a page 7.
ʠDrying result is not satisfactory
(laundry feels too damp).
Warm laundry feels damper than it actually is.
The selected programme does not suit the load.
Use another drying programme or, in addition, select the
time programme apage 7.
Use fine adjustment for the drying result
apage1/2 and 6.
Fine layer of limescale on the humidity sensors
a Clean the humidity sensors apage 9.
Programme termination, e.g. tank full, mains power supply
failure, door open or maximum drying time reached.
ʠDrying time too long. Rinse the fluff filters under running water a page 4.
Insufficient supply of air a ensure that air can circulate.
Air inlet possibly blocked a Clear inlet apage 8.
Ambient temperature higher than 35 °C a ventilate the
room.
ʠThe humidity in the room
increases significantly.
Make sure the room is sufficiently ventilated.
ʠPower failure. Remove laundry from the dryer immediately and spread out.
This allows the heat to dissipate.
ʠOther intermittent noises and
vibrations.
Not an error.
Normal noises apage 11.
ʠLoud humming noise for several
seconds.
Has the condensation container been properly inserted?
a Push the condensation container all the way in.
Not an error. Normal noises apage 11.
13
Safety instructions
Emergency
Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
dryer...
in rooms inside the house.
to dry fabrics.
The dryer must
NEVER...
be used for purposes other than those described above.
be modified in terms of its technology or properties.
Hazards
The dryer must not be used by children or persons who have not been
instructed in its use.
Do not leave children unsupervised near the dryer.
Keep pets away from the dryer.
Remove all objects from pockets, and lighters in particular a Risk of
explosion.
Do not lean or sit on the door a Risk of tipping.
Installation
Secure loose cables a Risk of tripping.
Do not operate a dryer if there is a risk of frost.
Mains
connection
Connect the dryer to an AC earthed socket according to specifications,
otherwise it cannot be guaranteed that the appliance is completely safe.
The cable cross-section must be sufficient.
Only use earth-leakage circuit breakers with the following symbol:
The appliance plug and socket must be compatible.
Do not use multiple plugs/connectors and/or extension cables.
Do not touch or hold the appliance plug with wet hands
a Risk of electric shock.
Never pull the appliance plug out of the socket by its cable.
Do not damage the mains lead a Risk of electric shock.
Operation
Only load the drum with laundry.
Check the contents before you switch the dryer on.
Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair styling products, nail varnish remover, stain
remover, cleaning solvent, etc.) a Risk of fire/explosion.
Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer
aRisk of explosion
Do not put laundry containing foamed material/rubber in the dryer a elastic
material may be destroyed and the dryer be damaged due to possible
deformation of the foamed material.
When cleaning the fluff filter, make sure that no foreign material (down or
filling material) gets into the air duct opening. If necessary, clean the drum
beforehand with a vacuum cleaner. If foreign material should still get into the
air duct a call the after-sales service a Risk of fire/explosion.
Switch off the dryer once the programme has ended.
The water from condensation is not drinking water and may be contaminated
with fluff.
Defect
Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
Do not use the dryer if the mains cable is defective. To avoid danger, only
have the defective mains cable replaced by the after-sales service.
Always pull the mains plug out of the socket before changing the bulb for
the interior light a Risk of electric shock.
Spare parts
Only use genuine spare parts and accessories for safety reasons.
Disposal
Pull out the appliance plug, then cut off the mains cable from the appliance.
Dispose of at a municipal waste disposal facility.
Heat exchangers contain a fluorinated greenhouse gas covered by the
Kyoto protocol (R134a) a dispose of in a proper manner.
Capacity: 0.22 kg.
Packaging: Keep all packaging out of reach of babies and children
a Risk of suffocation.
All materials are environmentally sound and can be reused.
Dispose of in an environmentally-responsible manner.
Dryer
en Instruction manual
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WTW84160GB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WTW84160GB in the language / languages: English as an attachment in your email.

The manual is 3.05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info