309461
7
Zoom out
Zoom in
Previous page
1/8
Next page
ŷƢƝƚƟƨƞƟƑ
ƌƥƭơƖƨƞƧƨƑ
ƣƩƵƨ
i j ſƵƣƨƤƨ ƫƢƝƖƩƱƥƚ S
=
ƊƩƴƤƭƫƠ
ŻƩƖƔƧƝƜƨƖƈƩƢƝƚƨƞƟƑ
ƣƩƵƨ
i j ſƵƣƨƤƨ ƫƢƝƖƩƱƥƚ S
=
ŷƢƑơƚƞƟƨƖ
i j ſƵƣƨƤƨ ƫƢƝƖƩƱƥƚ S
=
ŻƩƖƝƓ
ƣƩƵƨ
i j ſƵƣƨƤƨ ƫƢƝƖƩƱƥƚ S
=
ƂƑƠƠƞƢƖ
ƣƩƵƨ
ä
ŹƥƓƘƤƥƤ
ƄƒƗƘƖƠơƖ ƈƨƱƬƞơƤ ŮƢƨƠƜƧƜ
i
ţƎŽƍƆƊƋƔƂ
ŻƦơƞƣƬƢƣƕ ƐƩƱƥƚƬƢƫƬƕ ƣƩƵƨ
ŻƦơƞƣƬƢƣƕ ƐƩƱƥƚƬƢƫƬƕ
ŻƦơƞƣƬƢƣƕ ƐƩƱƥƚƬƢƫƬƕ
ŻƦơƞƣƬƢƣƕ ƐƩƱƥƚƬƢƫƬƕ
j
ŻƦơƞƣƬƢƣƕ ƐƩƱƥƚƬƢƫƬƕ
ſƭƚƘƫơƠƬƚ ƌƭƦơƞƬƢƣƕ
ŻƦƕƥƞƢƣƬƚ
ſƭƚơƗ ƣƩƵƨ
ƆƕƤƤƢƦƚ ƣƩƵƨ
ƆƕƤƤƢƦƚ
ŷƢƑơƚƞƟƨƖ
9
Care
Before washing for the first time
Do not put any laundry in the machine. Turn on the tap, add approximately 1 litre of water and
then ½ a measuring cup of detergent into compartment II. Turn the programme selector to
ŻƩƖƔƧƝƜƨƖ ƈƩƢƝƚƨƞƟƑ (Easy-Care) 60 °C and choose Start/Pause $. At the end of the
programme, turn the programme selector to Off.
Machine housing, control panel
Wipe with a soft, damp cloth.
Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
Remove detergent and cleaning agent residue immediately.
Do not clean with a jet of water.
Cleaning the detergent drawer ...
... if it contains detergent or fabric softener residues.
1. Pull out, press insert down, remove draw completely.
2. To remove the insert: press the insert upwards from below with your
finger.
3. Clean the detergent dispenser tray and insert with water and a brush and
dry it.
4. Attach the insert and engage (connect the cylinder to the guide pin).
5. Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can
evaporate.
Drum
Leave the washing machine door open so that the drum can dry out.
Rust stains - use chlorine-free cleaning agent, not steel wool.
Descaling Ensure there is no laundry in the machine
Descale the appliance according to the descaler manufacturer's instructions. This should not
be necessary if the correct dosage of detergent is used.
Information on the indicator lights model-dependent
A signal sounds and indicator lights for the spin speed flash:
¤
¤
¤
¤
¤
Close the washing
machine door properly;
laundry may be caught.
¤
¤
¤
¤
¤
Detergent solution pump
blocked; Clean the
detergent solution pump
–> page 10.
Drainage hose/waste pipe
blocked; Clean the drainage
hose at the siphon
–> page 10.
¤
¤
¤
¤
¤
Open the tap completely,
supply hose kinked or
trapped;
Clean the filter
–> page 10,
Water pressure too low.
¤
¤
¤
¤
¤
Motor fault. Call the after-
sales service.
¤
¤
¤
¤
¤
Water in the base tub,
appliance leaking. Call the
after-sales service.
Risk of electric shock. Disconnect the
mains plug.
Risk of explosion. No solvents.
10
Maintenance
Detergent solution pump
Turn the programme selector to Off and disconnect the mains plug.
1. Open and remove the service flap.
2. For models with a drainage hose: Remove the drainage hose from the retainer and pull it
from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
2* For models without a drainage hose: Carefully unscrew the pump cover until the
detergent solution begins to flow out. When the service flap is half full, close the pump cover
and empty the service flap. Repeat the above steps until all the detergent solution has
completely drained out.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in the detergent
solution pump must rotate).
5. Replace the pump cover and screw it tightly in place.
6. Place the service flap back on and close.
To prevent unused detergent from flowing straight into the drain during the next wash: pour 1 litre of water into
compartment II and start the ŮƢƨƠƜƧƜ (Empty) programme.
Drainage hose at the siphon
Turn the programme selector to Off and disconnect the mains plug.
1. Loosen the hose clamp, carefully remove the drainage hose (residual water).
2. Clean the drainage hose and siphon connecting piece.
3. Reattach the drainage hose and secure the connection with the hose clamp.
Filter in the water supply
Risk of electric shock.
Do not immerse the HydroSafe safety device in water (it contains an electric valve).
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except for ƄƒƗƘƖƠơƖ/ƈƨƱƬƞơƤ/ŮƢƨƠƜƧƜ(Rinse/Spin/Empty)).
3. Select Start/Pause $. Let the programme run for approximately 40 seconds.
4. Turn the programme selector to Off. Disconnect the mains plug.
Clean the filter:
1. Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and Aqua-Secure models:
Remove the hose on the rear of the appliance.
Remove the filter with pliers and clean.
2. Connect the hose and check for leaks.
Risk of scalding.
Allow the detergent solution to cool down.
Turn off the tap.
ʑ
ʑ
$
ʑ
ƱƩƘƪ ƌƬƵưƢƥƨ
ʑ
$
ʑ
ƱƩƘƪ ƌƬƵưƢƥƨ
ʑ
ʑ
ŻƱƟƤƠƤ ƧƞƙƒƥƭơƖ S
ʑ
ʑ
ʑ
ŷƢƝƚƟƨƞƟƑ ƌƥƭơƖƨƞƧƨƑ
ʑ
ʑ
ʑ
ʑ
ʑ
ƄƒƗƘƖƠơƖ ƌƬƵưƢƥƨ
7


Need help? Post your question in this forum.

Forumrules
1

Forum

bosch-wae-24162

Reset search

  • My new washing machine won't start. The door is properly closed and it still won't start?

    The model is a Bosch WAK 24162 Submitted on 24-8-2018 at 22:01

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch wae 24162 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch wae 24162 in the language / languages: English, Spanish as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch wae 24162

Bosch wae 24162 User Manual - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info