601043
32
Zoom out
Zoom in
Previous page
1/96
Next page
28
Robert Bosch Hausgeräte GmbH
en
The aromaDouble Shot function is activated
with the following settings:
Before using for
the rst time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines). Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see “Menu settings”
Water hardness).
Switching on the appliance
Remove the protective lm.
Place the fully automatic espresso
machine on a at, waterresistant surface
that can take its weight. Make sure that
the machine’s ventilation slots remain
unobstructured.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
Pull the power cord out of the storage
compartment (21) and plug in. Adjust the
length of the cable by pushing it back in
or pulling it out. The easiest way to do
this is to place the appliance so that its
back is ush with the edge of the counter
and either pull the cable downward or
push it upward.
Install the milk frother. Operate the
machine only after the milk frother (6) has
been fully assembled and installed.
Lift the lid of the water tank (18).
Remove and rinse the water tank (17)
and ll it with fresh cold water.
Do not ll above the max mark.
Replace the water tank (17) and push it
rmly downward into place.
Close the lid of the water tank (18) again.
Fill the bean container (1) with coffee
beans (for preparation using ground
coffee, see “Preparation using
ground coffee”).
Press the power switch O / I (9). The
display (16) shows the menu for setting
the display language.
Select the required display language with
the upper rotary knob (15).
Place a receptacle under outlet (6a).
Press the start button (10).
The language you selected is saved.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch TES51551 - VeroCafe LattePro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch TES51551 - VeroCafe LattePro in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info