552110
6
Zoom out
Zoom in
Previous page
1/9
Next page
6
03/2013
REVERSE THE DOOR OPENING
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stop, the device must be disconnected from the power supply. Always unplug
the device first.
1. Use a screw-driver to remove the screw covers
(11) at the device top cover. Unscrew the below
screws (10) and remove the device cover (9).
2. Put the blind cap (8) of the device top cover (9) at
the opposite side.
3. Dismount the upper door hinge (5) by unscrewing
the screws (6). Open the door a little, take the
door carefully from the lower door hinge (2).
4. Put the blind cap (7) of the device door at the
opposite side and place the door on a padded
surface to prevent it from scratches.
5. Tilt the device slightly backwards and block it in
this position. Unscrew both feet (3) and (4) and
remove the lower door hinge (2) by unscrewing
the screws (1).
6. Move the hinge (2) to the other side of the device accordingly and fix it with the screws (1).
Screw both feet (3) and (4) on again.
7. Replace the device in the upright position again. Insert the device door on the hinge pin of the low-
er door hinge (2) and fix the door to the property position.
8. Attach the upper door hinge (5) by using the screws (6) to the opposite side accordingly.
9. Put the in point 1 removed device top cover on again, tight the screws (10) and clip the screw co-
vers (11) on.
Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of
the door is ensured.
STARTUP / OPERATION
Prior to first use
ATTENTION
After transport, the device should be left standing for 4 hours in order for the oil to be collected in the
compressor.
Nonobservance could cause damage to the compressor and hence result in failure of the
device. This would void your warranty claim.
Clean the interior of the device including all accessory parts located inside.
Connect the device to the mains supply
IMPORTANT
The device must be earthed properly. For this purpose the plug of the mains cable has been fitted
with the intended lead.
Contact an electrician if the plug does not fit in the wall socket.
In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting
the device.
Turning on
Turn on the device by connecting the plug to a wall socket and turning the temperature control, which
is located at the device front. Please also refer to chapter “Settings“.
Settings
The Settings MIN – MAX regulate the inside temperature.
Setting MIN = lowest setting (warmest inside temperature)
Setting MAX = highest setting (coldest inside temperature)
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann GS 265 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann GS 265 in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann GS 265

Bomann GS 265 User Manual - German - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info