581564
34
Zoom out
Zoom in
Previous page
1/36
Next page
34
EN
6 Suggested solutions for problems
Drying process takes too much time
Meshes of the filter may be clogged. Wash with water
Laundry comes out wet at the end of drying.
Meshes of the filter may be clogged. Wash with water.
Excessive laundry might have been loaded in. Do not load the dryer in excess.
Dryer does not switch on or the programme does not start. Dryer is not activated when set.
It might have not been plugged in. Make sure that the machine is plugged in.
The loading door may be ajar. Make sure that the loading door is properly closed.
Programme might have not been set or the «Start/Pause/Cancel» button might have not been
pressed. Make sure that the programme has been set and it is not in “Pause” mode.
«Childproof lock» might have been activated. Deactivate the childproof lock.
Programme has been interrupted without any cause.
The loading door may be ajar. Make sure that the loading door is properly closed.
Electricity may be cut off. Press «Start/Pause/Cancel» button to start the programme.
Water may be full. Drain the water in the tank.
Laundry has shrunk, become felted or deteriorated.
A programme suitable for the laundry type might have not been used. Dry only the laundry which
is suitable for drying in dryer after checking the labels on your clothes.
Select a programme with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on. (For models with lamp)
Dryer might have not been started by using the «On/Off» button. Make sure that the dryer is on.
Bulb may have blown. Call the authorized service to replace the bulb.
“Final / Anti-creasing” LED flashes.
The 2-hour anti creasing programme to prevent laundry from creasing might have been activated.
Turn off the dryer and take out the laundry.
“Final / Anti-creasing” LED is on.
Programme has come to an end. Turn off the dryer and take out the laundry.
The “Drying” LED flashes.
A heat sensor failure has occurred. Dryer ends the programme without heating. Turn off the dryer
and take out the laundry. Call your authorized service
“Filter cleaning” LED is on.
Filter might have not been cleaned. Clean the cover filter.
“Water comes out the cover”
Clean the entire inner surface of the cover and door gasket.
“Cover opens spontaneously.”
Push it until you hear that it is closed.
For products with a condenser:
“Water tank” warning LED is on.
Water may be full. Drain the water in the tank.
“Condenser cleaning” LED is on.
Condenser might have not been cleaned. Clean the filters in the condenser under the kick plate.
A Call an authorized service if the problem persists.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg TKF 8239 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg TKF 8239 in the language / languages: English, German as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info