474608
12
Zoom out
Zoom in
Previous page
1/14
Next page
12
Störung Mögliche Ursache Abhilfe
Gerät arbeitet nicht
Gerät ist nicht eingeschaltet Gerät einschalten.
Die Lebensmittel sind zu warm.
Netzstecker ist nicht eingesteckt oder lose. Netzstecker einstecken.
Sicherung hat ausgelöst oder ist defekt. Sicherung überprüfen, gegebenenfalls
erneuern.
Innenbeleuchtung funktioniert nicht
Steckdose ist defekt. Störungen am Stromnetz behebt Ihr Elektro-
fachmann.
Gerät kühlt zu stark.
Temperatur ist zu kalt eingestellt. Temperaturregler vorübergehend auf wär-
mere Einstellung drehen.
Das Gerät steht neben einer Wärmequelle.
Temperatur ist nicht richtig eingestellt. Bitte im Abschnitt "Inbetriebnahme" nachse-
hen.
Lampe ist defekt. Bitte im Abschnitt "Lampe auswechseln"
nachsehen.
Temperaturregler vorübergehend auf kältere
Einstellung drehen.
Tür war längere Zeit geöffnet.
Bitte im Abschnitt "Aufstellort" nachsehen.
Innerhalb der letzten 24 Stunden wurden
größere Mengen warmer Lebensmittel ein-
gelagert.
Tür nur so lange wie nötig geöffnet lassen.
Starke Reifbildung im Gerät, evtl. auch an
der Türdichtung.
Türdichtung ist undicht (evtl. nach Türan-
schlagwechsel).
An den undichten Stellen Türdichtung vor-
sichtig mit einem Foen® erwärmen (nicht
wärmer als ca. 50 °C). Gleichzeitig die
erwärmte Türdichtung von Hand so in Form
ziehen, daß sie wieder einwandfrei anliegt.
Ungewöhnliche Geräusche.
Gerät hat Kontakt mit der Wand oder mit
anderen Gegenständen.
Gerät steht nicht gerade.
Ein Teil, z. B. ein Rohr, an der Geräterück-
seite berührt ein anderes Geräteteil oder die
Wand.
Gegebenenfalls dieses Teil vorsichtig weg-
biegen.
Gerät etwas wegrücken.
Verstellfüße nachjustieren.
Der Kompressor läuft nach einiger Zeit
selbsttätig an.
Siehe Abschnitt „Reinigung und Pflege“
Dies ist normal, es liegt keine Störung vor.Nach Änderung der Temperatureinstellung
läuf der Kompressor nicht sofort an.
Wasser am Kühlraumboden oder auf
Abstellflächen.
Tauwasser-Ablaufloch ist verstopft.
Abhilfe bei Störungen
Möglicherweise handelt es sich bei einer Störung nur
um einen kleinen Fehler, den Sie anhand nachfolgen-
der Hinweise selbst beheben können. Führen Sie kei-
ne weiteren Arbeiten selbst aus, wenn nachstehende
Informationen im konkreten Fall nicht weiterhelfen.
Warnung! Reparaturen am Kältegerät dürfen
Was tun, wenn ...
nur von Fachkräften durchgeführt werden. Durch
unsachgemäße Reparaturen können erhebliche
Gefahren für den Benutzer entstehen. Wenden
Sie sich im Reparaturfall an Ihren Fachhändler
oder an unseren Kundendienst.
17
Disposal
Appliance Packaging Information
All materials are environmentally sound! They can be
dumped or burned at an incinerating plant without
danger!
About the materials: The plastics can be recycled and
are identified as follows:
>PE< for polyethylene, e.g. the outer covering and the
bags in the interior.
>PS< for polystyrene foam, e.g. the pads, which are
all free of chlorofluorocarbon.
The carton parts are made from recycled paper and
should be disposed of at a waste-paper recycling
collection location.
Disposal of old Appliances
For environmental reasons, refrigeration appliances
must be disposed of properly. This applies to your old
appliance, and - at the end of its service life - for your
new appliance as well.
Warning! Before disposing of old appliances
make them inoperable. Remove plug from mains, sev-
er the power cable, remove or destroy any snap or
latch closures. This eliminates the danger that playing
children lock themselves into the appliance (danger of
suffocation!) or place themselves into other life-
endangering situations.
Disposal:
The appliance may not be disposed of with
domestic waste or bulky refuse.
The refrigerant circuit, especially the heat
exchanger at the back of the appliance, may not
be damaged.
Information concerning collection schedules or
locations can be obtained from the local disposal
authorities or town hall.
The appliance and the interior fittings are protected
for transport.
Pull off the adhesive tape on the left and right
side of the door.
Remove transport safeguard
Remove all adhesive tape and packing pie-
ces from the interior of the appliance.
Installation
Installation Location
The appliance should be set up in a well ventilated,
dry room.
Energy use is affected by the ambient temperature.
The appliance should therefore
not be exposed to direct sunlight;
not be installed next to radiators, cookers or other
sources of heat;
only be installed at a location whose ambient
temperature corresponds to the climate classifi-
cation, for which the appliance is designed.
The climate classification can be found on the serial
plate, which is located at the left on the inside of the
appliance.
The following table shows which ambient temperatu-
re is correct for each climate classification: each cli-
mate classification:
Climate classification for an ambient temperature of
SN +10 bis +32 °C
N +16 bis +32 °C
ST +18 bis +38 °C
T +18 bis +43 °C
If installation next to a source of heat is unavoidable,
the following minimum clearances must be maintai-
ned at the sides of the appliance:
for electric cookers 3 cm;
for oil and coal fired ranges 30 cm.
If these clearances cannot be maintained a heat insu-
lating pad is required between the cooker and the ref-
rigeration appliance.
If the refrigeration appliance is installed next to ano-
ther refrigerator or freezer a clearance of 5 cm at the
sides is required, in order to prevent the formation of
condensation on the outside of the appliance.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg KI 1221 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg KI 1221 in the language / languages: English, German as an attachment in your email.

The manual is 0,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info