167451
4
Zoom out
Zoom in
Previous page
1/12
Next page
THA 480
4
Connection of car radio with cinch output ..... Fig. 3
Loudspeaker connections ..................... Fig. 4/4a/5
+12V
Connect remote amplifier connection to switchable
+12 V power source.
This enables the amplifier to be switched on and off
with the radio’s On/Off switch.
Level control
The Level control enables the input sensitivity of the
final stage to be matched to the output voltage of
your car radio preamp output.
The range of adjustment extends from 0.3 V to 8 V.
Adjust the input sensitivity in accordance with the
manufacturers specifications when connecting the
amplifier to other radios.
Important:
Turning the Level control clockwise increases the in-
put sensitivity of the amplifier, and thereby also the
volume. The Level control is however not a volume
control; an increase in volume is not achieved in the
maximum position, even if this subjectively appears
to be the case. The system merely increases the
volume more quickly when the volume is turned up
on the radio.
Loudspeaker connections
(If the amplifier is to be connected in a bridged mode,
proceed with the section “Bridged loudspeaker con-
nections”.)
As with any audio component, connection of the
amplifier and speakers with the correct polarity is
essential for good bass reproduction. Ensure there-
fore when connecting that the positive (+) amplifier
terminal is connected to the positive (+) loudspeaker
terminal. The same applies to the negative (-) termi-
nals. The left-hand amplifier channel must also be
connected to the left-hand loudspeaker and the right-
hand amplifier channel to the right-hand loudspeaker.
Bridged loudspeaker connections
The THA can also be bridged in a mono configura-
tion. This enables you to use the amplifier for one or
more subwoofer(s) or a mid-range speaker. In this
configuration the amplifier sums the right-hand and
left-hand channels, delivering a single channel (mono)
output.
Note:
The amplifier can sum the right- and left-hand signal
information only if both the right- and left-hand RCA
connections have been made.
CAUTION:
The amplifier must be presented with a load
of 4 Ohms or higher in bridged mode. A lower
load will cause the amplifier to overheat or switch
off. This can lead to permanent damage of the
unit.
Adjustment of the type and range of the
cross-over frequencies
The type of crossover (i.e. “low-pass” or “hi-pass”)
and the desired crossover frequency can be selected
on the THA 480. If, for example, you wish to drive a
pair of subwoofers, connect in accordance with the
low-pass diagram (Fig. 3). The crossover frequency
is dependent upon the loud-speaker frequency range
(consult the loudspeaker manufacturers data for the
recommended frequency range).
“High- Pass”
At a of 250 Hz , the loudspeaker has a frequency
range of 250 Hz to 30.000 Hz.
“Low-pass” frequency control
This control is active when the switch is set to “Low-
pass” and permits selection of the desired crossover
frequency. Example: at a setting of 150 Hz, the loud-
speaker has a frequency range of 10 Hz to 150 Hz.
Operating indicator
(POWER / PROTECTION)
Green lamp: Power amp on, regular operating
condition
Red lamp: Power amp has been switched off
electronically, due to a fault or failure.
This information is subject to change without no-
tice!
FRANÇAIS
Introduction
Félicitations! Vous avez acheté un amplificateur THA
haut de gamme. En optant pour un THA 480 vous
avez choisi une reproduction du son de très haute
qualité. Que vous intégriez l‘amplificateur THA dans
un système déjà existant ou dans un nouveau sys-
tème hi-fi, l‘amélioration de la qualité du son, que
vous aurez bien du mal à ne pas remarquer, vous
convaincra dès le premier instant d‘écoute!
Blaupunkt s’efforce en permanence de rendre les
instructions de service de ses appareils toujours plus
claires et de lecture facile. Si malgré cela, vous émet-
tiez des doutes sur un point quelconque du manuel,
n’hésitez pas à vous adresser à votre représentant
agréé Blaupunkt ou à composer le numéro du centre
d’assistance téléphonique de votre pays (hot line).
Vous trouverez celui-ci à la dernière page de ce fas-
cicule.
Notre garantie s’étend à tous les produits achetés à
l’intérieur de l’Union Européenne. Vous en trouverez
les conditions sur notre site Internet :
www.blaupunkt.de. Vous pourrez aussi les obtenir
en vous adressant à :
Blaupunkt GmbH
Hotline
Robert Bosch Str. 200
D-31139 Hildesheim
Recommandation :
La performance d‘un amplificateur est toujours fonc-
tion de son installation, une installation correcte amé-
liorant la performance d‘ensemble du système audio.
L‘amplificateur THA devrait être installé par un ex-
pert; au cas où ce serait vous à vouloir l‘installer, li-
sez d‘abord ce mode d‘emploi sans rien omettre, puis
effectuez l‘installation en prenant le temps
nécessaire.Pour conclure, permettez-nous de vous
donner encore quelques conseils, notamment en
matière de protection de la santé :écouter de la mu-
sique dans un véhicule à un niveau dépassant 100
décibels, peut endommager l‘ouïe humaine de fa-
çon irrémédiable, voire occasionner sa perte totale.
Avec les systèmes modernes, très puissants, et des
haut-parleurs haut de gamme, il est possible de dé-
passer le niveau de pression sonore de 130 déci-
bels.
Consignes de sécurité
Dispositions relatives à l‘installation et
au branchement
Le câble électrique de l‘amplificateur doit être équipé
d‘un fusible placé à une distance maximale de 30
cm par rapport à la batterie du véhicule, pour proté-
ger celle-ci en cas de court-circuit entre l‘amplifica-
teur et la batterie. Le fusible de l‘amplificateur ne pro-
tège que ce dernier, non la batterie du véhicule. Pen-
dant le montage et le branchement de l‘amplifi-
cateur, le pôle négatif de la batterie doit être dé-
connecté.
Effectuer l‘installation en observant les consignes de
sécurité du fabricant du véhicule (air bag, équipe-
ment d‘alarme, ordinateur de bord, dispositif
d‘antidémarrage).
Pour prévenir les accidents, il est nécessaire que
l‘étage amplificateur de puissance soit fixé de façon
professionnelle. Il doit être possible d‘introduire les
vis livrées avec l‘amplificateur dans la surface de
montage, qui, elle, doit offrir un support sûr. Pour
des raisons de sécurité, le THA 480 doit être fixé de
façon sûre. Ne pas le monter surles plages arriè-
res, les banquettes arrières ou sur toute autre
surface ouverte vers l’avant.
En perçant des trous, il est nécessaire de faire atten-
tion à ne pas endommager des pièces du véhicule
telles que la batterie, les câbles ou la boîte à fusi-
bles.
L‘amplificateur doit être installé à un endroit conve-
nable, p. ex. sous les sièges ou dans le coffre
(Fig. 1). Lors du choix de l‘emplacement, veillez à ce
que celui-ci soit sec et que l‘air y circule suffisam-
ment pour assurer le refroidissement de l‘amplifica-
teur. Si le bord des trous est tranchant, utilisez un
cheminement de câbles. Utilisez des haut-parleurs
ayant une impédance de 2-4 (Cf. tableau ou des-
sin de montage). Faites attention à la charge maxi-
male (puissance sonore). Ne reliez les haut-parleurs
à la terre, n‘utilisez que les bornes marquées. La sec-
tion des câbles +/- ne doit pas être inférieure à
6 mm
2
.
Amplifier THA 480
Cet amplificateur est conçu pour le rattachement à
une prise Cinch d‘autoradio.
Si l‘autoradio est équipé d‘une prise ISO
Blaupunkt, utiliser un adaptateur ISO-Cinch
(7 607 893 093 / 7 607 855 094).
Possibilités d‘emploi et branchement des
haut-parleurs :
Stereo-Mode
Max Power 4 x 300 Watt / 4 Fig. 4, 4a
Mono-Mode
Max Power 2 x 600 Watt / 4 Fig. 5
Stereo-Mode
Max Power 4 x 300 Watt / 2 Fig. 4, 4a
Stereo-Mode
RMS Power 4 x 80 Watt / 4 Fig. 4, 4a
Mono-Mode
RMS Power 2 x 200 Watt / 4 Fig. 5
Stereo-Mode
RMS Power 4 x 120 Watt / 2 Fig. 4, 4a
Réponse
hormonique 10 Hz - 30.000 Hz
Rapport signal
bruit > 100 dB
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt tha 480 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt tha 480 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info