Manual Blaupunkt monte carlo tcm 169 (page 4 of 23) (English, German, Dutch, French, Italian, Portuguese, Swedish)

167437

Zoom out

Zoom in

1/23

- 4 -

8 622 401 885

Safety information

- If this equipment is installed or serviced incorrectly,

this could result in malfunctions in the vehicle electro-

nics.

- To prevent damage to your Radiophone, make sure to

use only a corresponding adapter cable to connect the

8-pin +/- ISO plug in the vehicle.

While installing and connecting this equipment, please

observe the following safety information:

- Disconnect the negative terminal of the battery.

- Observe any safety instructions provided by the ve-

hicle manufacturer.

- When drilling any holes, make sure that you do not

damage any vehicle parts.

- The cross-section of the positive and negative wire

must not exceed 1.5 mm

Installation instructions

Congratulations on deciding to purchase a Blaupunkt

Radiophone. If you would like to install it yourself, please

observe the following installation instructions to ensure that

your equipment will operate properly. If the installation

situation is different to the one described here, please consult

a Radiophone Service Center.

1. Connecting the power

1.1 Connection to the vehicle ISO standard plug

To prevent faulty electrical connections with vehicle ISO

plugs, you must use the universal ISO adapter cable

(order no. 7 607 621 126) (see Fig. 1).

10A

For VW Golf IVs and Passats built in 1997 and later,

it is necessary to cut through the yellow/green wire

of the universal adapter cable. The ends of the wire

must be insulated!

1.2 Connecting the equipment in vehicles which are

not prepared for car radio installation

In vehicles which are not prepared for car radio

installation or when the positive/negative wire is too thin

(< 1.5 mm

), the enclosed ISO +/- connection cable

(can be identified by the brown, orange, yellow/green

and two red wires) must be connected to the universal

power lead (available in retail outlets, order no.

7 607 884 093) according to Fig. 2, page 6.

7 607 621 126

Fig. 1

2. Connecting the speakers

2.1 Speaker connection to the ISO standard plug

If the vehicle is passively prepared for car radio

installation (with 4-ohm speakers), you can adapt the

ISO plug in the vehicle. If necessary, it can be extended

by adding the ISO cable (7 607 647 093).

If the vehicle is actively prepared for car radio

installation, you can obtain the special adapter cables

from your retailer.

2.2 Connecting the speakers in vehicles with no

preparation for radio installation

For retro-fitted speakers, you must use the enclosed ISO

speaker wires . The connection between the ISO

speaker wire and the speakers can be made using

insulating screw joints (not included) (see Fig. 4, page 22).

3. Connecting the antenna

Bosch/Blaupunkt has a large selection of antenna types

available which have been specially designed for your

Radiophone. Your dealer is able to provide more

information.

3.1 Radio antenna

In pre-fitted vehicles (e.g.: VW, Seat, Audi), the power

supply for the antenna is fed in via the antenna cable

(refer to vehicle operating instructions). If the OEM radio

is replaced by a different radio, you must use an antenna

diplexer with a power lead (order no. 7 691 290 202, for

Audi: order no. 7 607 621 129), available from your

dealer. You will find information on how to mount and

connect the antenna in the antenna installation

instructions. Depending on the existing antenna, it may

be necessary to use the enclosed antenna adapter with

its holder (see Fig. 5, page 22).

3.2 Telephone antenna

After mounting the antenna, you have to screw down the

connection to the Radiophone firmly and then turn it

another quarter turn with a pair of pliers (connection, see

Fig. 5, page 22).

Note: Do not lay the telephone antenna wiring close to

the speaker wires.

3.3 GPS antenna (satellite navigation)

Depending on the installation situation, you can choose

between the NTR 101 (combination antenna for GPS,

radio, GSM) or the N 301 (GPS antenna only). the

installation of the antenna must be completed as

described in the installation instructions supplied with the

antenna (connection, see Fig. 5, page 22)

4. Radiophone installation

The Radiophone is installed in the car radio installation

compartment provided by the vehicle manufacturer (see

Fig. 6, page 22). For vehicles without a DIN

compartment, Blaupunkt supplies vehicle-specific

installation kits for 50/52 mm sets for the most popular

vehicle models. Check the installation conditions in your

vehicle and use a vehicle-specific installation kit if

necessary.

4.1 Steering wheel remote control unit

It is possible to use an interface to adapt existing vehicle

remote control units on the steering wheel in some

vehicles. Information is available from your dealer.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt monte carlo tcm 169 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish as an attachment in your email.

The manual is 0,45 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Blaupunkt monte carlo tcm 169 Manual

Product: