614232
1
Zoom out
Zoom in
Previous page
1/2
Next page
Draadloos Deur-/ Raamcontact (DC-S1)
Onderdelenbeschrijving
1. LED indicator
2. Leer-/testknop
Druk op de knop om een leer-/testcode te verzenden en ga in de
test-modus voor 3 minuten. De LED zal oplichten wanneer het
deur-/raamcontact onder testmodus wordt geactiveerd.
3. Toezicht in-/uitschakelen Jumper Switch (JP2)
4. Sabotage schakelaar
De sabotage schakelaar beschermt het deur-/raamcontact tegen
ongeautoriseerde verwijdering uit gemonteerde oppervlak.
5. Batterij vak
6. Doordrukgaten
7. Batterij isolator
8. Ribbel Markering
9. Magneet
Inhoud van de verpakking
1 x Deur-/ Raamcontact
4 x pluggen en schroeven
2 x kleef pads
1 x 3V 1/2AA lithium batterij (vooraf geïnstalleerd)
.
Zet het regelpaneel in leermodus, druk dan op de leerknop om een
leercode te verzenden. Raadpleeg de handleiding van het
regelpaneel om het leerproces te voltooien.
Het deur-/raamcontact heeft 2 uitsparingen voor wandmontage aan
de binnenkant van de achterklep waar het plastic dunner is.
Het deur-/raamcontact moet op het deur-/raamkozijn worden
gemonteerd, terwijl de magneet op de deur/raam moet worden
gemonteerd, zoals getoond in de afbeelding hieronder. Het deur-
/raamcontact heeft een Ribbel Markering aan één zijde om de
positie van de interne magnetische schakelaar te markeren. De
magneet moet op de hoogte van de Ribbel Markering worden
geplaatst bij montage. De ruimte tussen het deur-/raamcontact en
de magneet mag niet meer dan 15 mm bedragen
Bij bevestiging met schroeven:
1. Maak het deur-/raamcontact open door de schroef aan de
onderzijde los te draaien en het deksel te verwijderen
2. Boor gaten in de ondergrond en gebruik de doordrukgaten als
voorbeeld, bevestig dan het deur-/raamcontact met de
schroeven en eventueel de pluggen.
3. Bevestig het deksel weer en schroef het deur-/raamcontact weer
dicht
4. Bevestig de magneet op dezelfde wijze of met tape aan de deur
of het raam.
Bij bevestigen met tape:
1. Maak de ondergrond en het deur-/raamcontact goed schoon
en vetvrij zodat de tape goed blijft zitten. Voordat u de tape
bevestigd, dient de ondergrond droog te zijn.
2. Bevestig het deur-/raamcontact op het frame met de
meegeleverde dubbelzijdige tape.
3. Bevestig de magneet op dezelfde wijze of met een schroef
aan de deur of het raam.
Denk aan het volgende bij het monteren van het deur-/raamcontact:
Monteer zo hoog mogelijk
Richt PIR-sensor niet op dit venster
Niet bevestigen op metalen oppervlak
Test Modus
Druk op de testknop om voor 3 minuten de testmodus in te gaan.
In testmodus, zal de LED indicator elke keer oplichten wanneer
het deur-/raamcontact wordt geactiveerd.
LED Indicator
Uit
Normaal in gebruik
Aan (2
seconden)
De sabotage schakelaar is getriggerd;
Of er is beweging gedetecteerd terwijl de
batterij spanning laag is;
Of het contact staat in test mode.
Toezicht in-/uitschakelen Jumper Switch (JP2)
Als dit is ingeschakeld dan zendt het contact met regelmaat een
controle signaal naar het regelpaneel.
Jumper staat AAN = Toezicht functie is NIET ACTIEF
Jumper staat AAN = Toezicht functie is ACTIEF (Standaard)
Gebruik
Inleren
Installatie
Frame
Deur/
Raam
Jumper Aan
De jumper is verbonden
met allebei de pinnen
Jumper Uit
De jumper is verwijderd of
verbonden met maar 1 pin
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt DC-S1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt DC-S1 in the language / languages: Dutch as an attachment in your email.

The manual is 0,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Blaupunkt DC-S1

Blaupunkt DC-S1 User Manual - German - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info