165634

Blaupunkt bqx 320 Manual

2
Zoom out
Zoom in
Previous page
1/11
Next page
GB
Amplifier type
4/3/2-channel switching amplifier with integrated sub-bass crossover.
Installation
The amplifier BQX 320 can be connected to car radios equipped with a
PREAMP OUTPUT (DIN 45 326) or Cinch socket.
Use the adapter cable 7 607 873 000 (speaker plug DIN socket) to
connect the amplifier to a car radio with loudspeaker outputs. Several
amplifiers can be bridged via the 8-pin AUX OUT socket.
Safety Notes
Installation and connecting instructions
Disconnect the negative terminal of the battery during installation.
Select a suitable mounting place in the car for the BQX 320, e.g. at the
splashboard, below the dashboard, below the seats or in the boot. Make
sure the selected mounting place provides sufficient heat dissipation.
Prior to drilling the mounting holes, make sure that no cables and parts
of the vehicle will be damaged, fig. 1.
Leave ample clearance between the cables and other harnesses.
Use only loudspeakers having an impedance of 4 Ω. Observe the rated
maximum capacity (music power) of the selected loudspeakers.
Use speaker cables with a cross section between of up 16 mm
2
. Do not
connect the loudspeakers to ground, use only the marked terminals.
Possible applications
Function select switch
1 Full-range 4 x 80 W or 2 x 160 W
2 High-pass 4 x 80 W
3 High-pass 2 x 80 W
+
Low-pass 2 x 80 W or 1 x 160 W
4 Full-range 2 x 80 W
+
Low-pass 2 x 80 W or 1 x 160 W
5 Low-pass 2 x 160 W
Switch settings
Bass boost setting ON 10 dB bass boost at 45 Hz
80 Hz / 120 Hz Subwoofer crossover frequency
Plus/minus connection
Route the enclosed positive cable to the battery and connect it via the
fuse contact. Use the enclosed cable ducts at sharp-edged holes.
Screw the enclosed negative cable to an interference-free ground spot
(chassis screw or plate). Do not connect it to the negative terminal of the
battery. The contact area of the ground source must be blank and
lubricated with graphite grease.
Examples
Connection to car radios with DIN output Fig. 2
Connection to car radios with Cinch output Fig. 3
The settings of the crossover switch “80 Hz - 120 Hz” and “Bass Boost”
depends on the type of loudspeaker used, the accoustic properties of the
car interior and on personal preferences.
For frequencies, see product manual and specification.
When connecting the amplifier via Cinch or loudspeaker sockets, the
switching line must be connected.
Loudspeaker connection Fig, 4, 5, 6, 7
Function select 1 4 x 80 W or 2 x 160 W
Function select 2 4 x 80 W with subwoofing
Function select 3 2 x 80 W and 2 x 80 W
or 1 x 160 W with subwoofing
Function select 4 2 x 80 W and 2 x 80 W
or 1 x 160 W with subwoofing
Function select 5 2 x 160 W with subwoofing
GAIN ADJ
The Gain Adjust control button can be adjusted between 0.3 and 2 V.
When connecting a Blaupunkt car radio, adjust the control button to 2 V.
If a car radio of another brand shall be connected, adjust the input
sensitivity as detailed in the car radio specification.
Bass Level Adj
Use the bass level adjust control to set the subwoofer volume ± 10 dB.
Specification
Max. power: 2 x 80 W or 1 x 160 W into 4 Ω
RMS power: 2 x 40 W or 2 x 80 W with 1 % THD
(DIN 45500)
Distortion factor: < 0,01 % at 10 W, 1 kHz, 4 Ω
Frequency response: 10 Hz - 90 kHz (-3 dB)
Signal-to-noise ratio: >100 dB(A)
Channel separation: >60 dB / 1 kHz
Protected against short-circuit and overtemperature.
Inputs: 8-pin DIN, 4 x Cinch (RCA) gold-plated
Outputs: AUX OUT (8-pin DIN), 4 speaker outputs, 4 Ω gold-plated
Dimensions ( W x H x D): 350 x 45 x 270 mm
Changes reserved
F
Description du produit
Amplificateur 4/3/2 canaux avec bloc de commutation et diviseur de
fréquence subwoofer intégré.
Notice de montage
L’amplificateur BQX 320 est conçu pour le branchement sur les autoradios
munis d’un “PREAMP OUTPUT” conformément à la norme DIN 45 326
ou d’une prise Cinch.
Pour brancher l’appareil sur les autoradios équipés de sorties haut-
parleurs, utiliser le câble adaptateur 7 607 873 000 (prise mâle du haut-
parleur prise femelle DIN). La prise 8 pôles AUX OUT permet de
connecter plusieurs amplificateurs en même temps.
Recommandations de
sécurité
Consignes de montage et de branchement
Débrancher le pôle négatif de la batterie pendant toute la durée des
travaux de branchement et de montage de l’appareil.
Le BQX 320 doit être monté à un emplacement spécialement prévu p. ex.
sur le tablier d’auvent, sous le tableau de bord, sous les sièges ou dans
le coffre à bagages. L’emplacement de montage choisi devra permettre
une évacuation suffisante de la chaleur. Avant de percer les trous de
fixation, veiller à n’endommager ni câbles ni pièces déjà présents dans
le véhicule, fig. 1.
Poser tous les câbles à bonne distance des harnais de câbles afin
d’éviter tout parasitage.
Utiliser exclusivement des haut-parleurs d’impédance 4 Ω. Respecter
l’intensité maximum (puissance musicale efficace).
Pour le raccordement des haut-parleurs, utiliser des câbles pouvant aller
jusqu’ à 16 mm
2
. Ne pas mettre les haut-parleurs à la masse, n’utiliser
que les bornes indiquées.
Mise en service et sélections réalisables:
Sélecteur de fonction (Function Select)
1 Full Range 4 x 80 W ou 2 x 160 W
2 High Pass 4 x 80 W
3 High Pass 2 x 80 W
+
Low Pass 2 x 80 W ou 1 x 160 W
4 Full Range 2 x 80 W
+
Low Pass 2 x 80 W ou 1 x 160 W
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt bqx 320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt bqx 320 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 0,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info