581267
5
Zoom out
Zoom in
Previous page
1/12
Next page
5
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of
use and the way the tool is used, including taking account of
all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to
the trigger time.
Labels on tools
Additional safety instructions for batteries and chargers
Batteries
X Never attempt to open for any reason.
X Do not expose the battery to water.
X Do not store in locations where the temperature may
exceed 40 °C.
X Charge only at ambient temperatures between 10 °C
and 40 °C.
X Charge only using the chargers provided with the tool.
X When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
Chargers
X Use your Black & Decker charger only to charge the
battery with which it was supplied. Other batteries could
burst, causing personal injury and damage.
X Never attempt to charge non-rechargeable batteries.
X Have defective cords replaced immediately.
X Do not expose the charger to water.
X Do not open the charger.
X Do not probe the charger.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
X If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
1. Lock-off switch
2. On/off trigger switch
3. Blade clamp lever
4. Shoe
5. Blade
Assembly
Installing the battery pack (fig. A)
Warning! Make certain that the lock-off button is engaged to
prevent switch actuation before removing or installing
battery.
X Insert the metal terminal end of the battery pack (7) into
the battery compartment until you hear the lock click into
place and the VPX
TM
logo shows through the window.
Warning! The battery will only fit one way, do not force it. If
the battery does not fit, remove it and put it in the other way.
Removing the battery pack:
X Press the release button (6) and firmly pull the battery
pack out of the battery compartment.
Charging the batteries (fig. B)
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Note: The charger will not charge a battery pack if the cell
temperature is below approximately 0° C or above 60° C.
The battery pack should be left in the charger and the
charger will begin to charge automatically when the cell
temperature warms up or cools down.
X Plug in the charger (8) and switch on at the mains.
X Insert the battery pack (7) into the charger. Make sure
that the battery pack is fully seated in the charger (8).
X The charging indicator (9) will flash continuously
(slowly).
X Leave the battery to charge for at least 5 to 6 hours.
X The charge is complete when the charging indicator (9)
lights continuously
X The charger and the battery pack can be left connected
indefinitely with the LED illuminated. The LED will
change to flashing (charging) state, as the charger
occasionally “tops off“ the battery charge.
Warning! To reduce the risk of injury, the user must
read the instruction manual.
The charger is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the
ambient temperature becomes too high. As
soon as the ambient temperature has cooled
down, the charger will resume operating.
Charge only at ambient temperatures between
10 °C and 40 °C.
Charging.
+40ºC
+10ºC
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker VPX1301 T1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker VPX1301 T1 in the language / languages: English as an attachment in your email.

The manual is 0,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker VPX1301 T1

Black Decker VPX1301 T1 User Manual - English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info