319659
6
Zoom out
Zoom in
Previous page
1/12
Next page
6
ENGLISH
Never pull the charger lead to
disconnect the charger from
the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
Unplug the charger before
cleaning the charger or
charging base.
When not in use, the appliance
should be stored in a dry place.
Children should not have
access to stored appliances.
Inspection and repairs
Before use, check the appliance
for damaged or defective
parts. Check for breakage of
parts, damage to switches
and any other conditions that
may affect its operation.
Do not use the appliance if any
part is damaged or defective.
Have any damaged or
defective parts repaired or
replaced by an authorised
repair agent.
Regularly check the charger
lead for damage. Replace the
charger if the lead is
damaged or defective.
Never attempt to remove or
replace any parts other than
those specified in this manual.
Battery
Never attempt to open the
battery for any reason.
Do not expose the battery to
water.
Do not incinerate the battery.
When disposing of batteries,
follow the instructions given
in the section “Protecting the
Environment”.
Charger
Do not expose the charger to
water.
Do not open the charger.
ELECTRICAL SAFETY
Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base can be fitted
to the wall to provide a
convenient storage and charging
point for the appliance.
Find a suitable indoor
location near a mains outlet.
Position the charging base as
shown and mark the location
of the mounting holes (6) on
the wall.
Drill a hole (ø 6 mm, approx.
35 mm deep) at each of the
marked locations.
Insert the wall plugs provided
into the holes.
Fit the charging base to the
wall using the screws provided.
Make sure to guide the charger
lead through the slot (7).
Excess lead can be stored at
the rear of the charging base.
BEFORE FIRST USE
Before first use, the battery must
be charged for at least 16 hours.
Before charging, preferably
discharge the battery by
operating the appliance until
the motor stops.
Charge the battery as
described below.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker v 4810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker v 4810 in the language / languages: English as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker v 4810

Black Decker v 4810 User Manual - English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info