578639
3
Zoom out
Zoom in
Previous page
1/8
Next page
3
Intended use
Your Black & Decker radio/charger has been designed for
charging Black & Decker NiCd batteries and for playing radio
transmissions. This tool is intended for consumer use only.
Safety instructions
Warning! When using chargers, basic safety
precautions, including the following, should always be
followed to reduce the risk of fire, leaking batteries,
personal injury and material damage.
Read all of this manual carefully before operating the tool.
Retain this manual for future reference.
Chargers
Use your Black & Decker charger only to charge batteries
of the type and voltage as specified in the technical data.
Other batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 4 °C and
40 °C.
When disposing of batteries, follow the instructions given
in the section “Protecting the environment”.
Under extreme conditions, battery leakage may occur.
When you notice liquid on the battery, proceed as
follows:
- Carefully wipe the liquid off using a cloth. Avoid skin
contact.
- In case of skin or eye contact, follow the instructions
below.
Warning!! The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact, immediately
rinse with water. Neutralise with a mild acid such as lemon
juice or vinegar. In case of eye contact, rinse abundantly with
clean water for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a
detached battery (e.g. when storing the battery in a
toolbox).
Do not incinerate the battery.
Do not attempt to charge damaged batteries.
ELECTRICAL SAFETY
Your charger has been designed for a specific mains voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Your charger is double insulated in accordance with
EN 60335; therefore no earth wire is required.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Overview
1. Volume control
2. Mode selector
3. Station selector
4. Frequency scale
5. Adapter plug terminal
6. Tool rest
7. Aerial
8. Charging indicator
9. Battery receptacle
10. Storage
Fig. A
11. Mains adaptor
12. Adaptor plug
Assembly
Fitting the appliance to the wall (fig. B)
The appliance can be fitted to the wall to provide a convenient
charging point for batteries.
Find a suitable indoor location near a mains outlet.
Transfer the distance between the mounting slots (13) on
the back of the appliance to the wall.
Mark the location of the mounting holes (14) on the wall.
Drill a hole (ø 6 mm, approx. 35 mm deep) at each of the
marked locations.
Insert corresponding wall plugs into the holes.
Insert suitable screws (6 x 50 mm) into the plugs.
Hang the appliance on the screws.
Connecting the appliance to the mains (fig. A)
Warning! To ensure correct functioning, always make sure
the adapter plug is correctly oriented with the terminal.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker R123F2 T1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker R123F2 T1 in the language / languages: English as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info