665799
10
Zoom out
Zoom in
Previous page
1/62
Next page
8
Electrical safety
Make sure that the voltage of your hedgetrimmer is
correct for your supply. The voltage of your charger is
on the rating plate.
Introduction
Your charger is designed to charge all Black & Decker
batteries from 8.4 volts to 12 volts in about three
hours. Your charger needs no adjustment and is
designed to be as easy as possible to operate.
Simply place your battery into the receptacle of your
plugged in charger and it will automatically charge.
Description (Fig. A)
A
8. Charger
9. Battery
11. Wall and workbench mounting holes
Mounting your charger (Fig. C)
C1
Your charger is equipped with mounting
holes (12) to permanently fix it to a wall or
workbench. (It does not have to be mounted
to any surface in order to operate.)
Simply drill two 6mm holes by 36mm
deep in the appropriate position, insert
the wall plugs and secure the screws
provided.
If you are mounting the charger to a
hollow wall, use wall anchors.
Do not mount upside down.
Charging procedure (Fig. C)
C1
Insert your battery (9) into your charger.
Be sure that it is fully seated in your
charger.
Your battery will be fully charged in about
3 hours.
Your battery can be removed at any time.
Your charger and battery can be left
connected.
Your charger will keep your battery fresh
and fully charged.
Note: Your battery will slowly lose its charge
when kept out of a charger or if it is left in a
charger that is not plugged in. If your battery
has not been kept on charge, it may need to
be recharged before use.
Important charging notes
Longest life and best performance can be
obtained if your battery is charged when the air
temperature is about 24˚C. Do not charge your
battery in an air temperature below 4˚C, or
above 40˚C.
Whilst charging, your charger and battery may
become warm to touch. This is a normal
condition and does not indicate a problem.
If your battery does not charge properly,
proceed as follows:
Check the current at the socket by plugging in a
lamp or other appliance.
Move your charger and battery to a location
where the surrounding air temperature is about
24˚C. In an extremely warm environment your
battery may be too hot to permit charging.
If charging problems persist, take, or send, your
hedgetrimmer, battery and charger to your local
Black & Decker service centre.
Your battery should be recharged when it fails to
produce sufficient power on jobs which were
easily done previously. Do not continue to use
under these conditions. Follow the charging
procedure described previously. You may also
charge a partially used battery whenever you wish.
Batteries
Your charger will charge only Black & Decker
batteries. When ordering replacement batteries, be
sure to include the catalogue number and voltage.
Important!
Your charger is not user serviceable. There are no
user serviceable parts inside your charger. Servicing
at an authorised Black & Decker authorised repair
agent is required to avoid damage to static sensitive
internal components.
The Black & Decker after sales
service
All Black & Decker products are scrupulously tested
before leaving the factory. However, in the case of
your power tool being defective, please take it to your
nearest Black & Decker authorised repair agent.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker GTC390 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GTC390 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info