Manual Black Decker GTC18452PC (page 8 of 100) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

665777

Zoom out

Zoom in

1/100

ENGLISH

(Original instructions)

To install battery pack

u Insert battery (8) into tool until an audible click is heard

(Figure. B)

u Ensure battery pack is fully seated and fully latched into

position.

To remove battery pack

u Depress the battery release button as shown in gure C

and pull battery pack out of tool.

Assembly instructions

Warning! Make certain the battery is removed before assem-

bly or disassembly of any parts.

Assembly tools required (not supplied):- phillips screw-

driver.

Attaching guard and bail handle to trimmer

Warning! Only use with handle and guard properly assembled

to hedge trimmer. The use of the hedge trimmer without

the proper guard or handle provided may result in serious

personal injury.

The trimmer is shipped with the guard and bail handle at-

tached with a plastic zip tie.

To assemble to trimmer:

u Cut the plastic zip tie.

u Remove the six screws that are partially run into the trim-

mer housing (Figure D).

u Slide the guard (5) onto the front of the trimmer housing

as shown in gure E

u Insert two of the six screws into the openings on the sides

of the guard and tighten securely.

u Slide the bail handle (6) onto the front of the trimmer hous-

ing behind the guard as shown in gure F.

u Insert the remaining four screws into the openings on the

sides of the bail handle and tighten securely.

Operation

u To turn the unit on, push the lock off button (2) down,

squeeze the trigger (1) and depress the dual switch bail

handle(6), as shown in gure G. Once the unit is running,

you may release the lock-off button. In order to keep the

unit running you must continue to squeeze the trigger.

Warning! Never attempt to lock a switch in the on position.

Trimming Instructions

u Maintain proper footing and balance and do not overreach.

Wear safety goggles, non-skid footwear when trimming.

Hold the unit rmly in both hands and turn the unit ON.

Always hold the trimmer, as shown in the illustrations in

this manual, with one hand on the switch handle and one

hand on the bail handle (gure H). Never hold the unit by

the blade guard.

Trimming new growth (Fig. I)

u A wide, sweeping motion, feeding the blade teeth through

the twigs is most effective. A slight downward tilt of the

blade, in the direction of motion gives the best cutting.

Warning! Do not cut stems greater than 19mm.

Use the trimmer only for cutting normal shrubbery around

houses and buildings.

Level hedges (Fig. J)

u To obtain exceptionally level hedges a piece of string can

be stretched along the length of the hedge as a guide.

Side trimming hedges (Fig. K)

u Hold the trimmer as shown and begin at the bottom and

sweep up.

POWERCOMMAND

If you encounter a jam, depress the POWERCOMMAND

button (4) shown in gure l. The blades will move back and

forth in a slower, more forceful rhythm to help cut through dif-

cult branches. Release the button to return to normal hedge

trimming usage.

Note: Once the button is released, the blades will immediately

return to full speed.

Note: The blades will stop when the button is held for 15 sec-

onds. To reengage the POWERCOMMAND feature, release

the button and depress it again. DO NOT continuously hold

the POWERCOMMAND button during normal hedge trimming.

Maintenance

Your BLACK+DECKER corded/cordless appliance/tool has

been designed to operate over a long period of time with a

minimum of maintenance. Continuous satisfactory operation

depends upon proper tool care and regular cleaning.

Warning! Before performing any maintenance on corded/

cordless power tools:

u Switch off and unplug the appliance/tool.

u Or switch off and remove the battery from the appliance/

tool if the appliance/tool has a separate battery pack.

u Or run the battery down completely if it is integral and then

switch off.

u Unplug the charger before cleaning it. Your charger does

not require any maintenance apart from regular cleaning.

u Regularly clean the ventilation slots in your appliance/tool/

charger using a soft brush or dry cloth.

u Regularly clean the motor housing using a damp cloth. Do

not use any abrasive or solvent-based cleaner.

u After use, carefully clean the blades. After cleaning, apply

a lm of light machine oil to prevent the blades from rust-

ing.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GTC18452PC in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker GTC18452PC Manual

Product: