Manual Black Decker GT221 (page 6 of 40) (English, German, Dutch, French, Italian, Portuguese, Spanish)

665772

Zoom out

Zoom in

1/40

• The cable wire colours, or a letter, will be

marked at the connection points of most

good quality plugs. Attach the wires to

their respective points in the plug

(see above). Brown is for “Live” (L)

and blue is for “Neutral” (N).

• Before replacing the top cover of the

mains plug ensure that the cable restraint

is holding the outer sheath on the cable

firmly and that the two leads are correctly

fixed at the terminal screws.

Warning! Never connect live or neutral wires

to the earth pin marked “E” or .

Note: Do not wire an extension cable

directly into your machine yourself.

Instead, take your machine to your

nearest Black & Decker service centre.

Increased safety can be obtained by having

a qualified electrician install a high sensitivity

(30mA) circuit breaker in the house wiring.

If you do not wish to have one installed,

then we strongly recommend that the

electrical power to the machine be supplied

through a high sensitivity residual current

device (RCD). The RCD is designed to

provide a high degree of personal protection

against harmful electric current should fault

conditions occur.

Warning! The use of an RCD or other circuit

breaker unit does not release the operator of

the machine from the safety instructions and

safe working practices given in this manual.

We recommend that if your mains cable

is cut or requires replacement that you

return your machine to a Black & Decker

service centre. When repaired, your

machine will be tested for electrical safety.

Cable connection system (UK only)

Black & Decker continually make every effort to

achieve the highest standards in performance,

quality and reliability and recommend the use of a

new outdoor cable connection system.

The new system gives additional protection against

the possibility of water or moisture entering into the

cable connector during normal use.

Note: The new connection system does not release

the operator of the machine from the safety

precautions and safe working practices given in the

instruction leaflet. Particular attention is drawn to the

coupler system as being ‘weather resistant’ and not

suitable for immersion, submersion or being

subjected to water jets. Care should be taken to

prevent the cable from lying or trailing through pools

of water or from splashing with hose pipes.

ENGLISH

A6615 20m cable, socket, 13 amp plug

A6616 20m cable, socket, 13 amp plug and cable

tidy frame

A6617 30m cable, socket, 13 amp plug and cable

tidy frame

A6613 40m cable, socket, 13 amp plug and cable

tidy reel

Existing cable systems (UK only)

If you already own an outdoor cable system,

we recommend that you replace the existing

‘female’ cable connector with the new ‘female’

connector (see below) which is supplied loose in

the carton. (Please read the section entitled

“Fitting the ‘female’ connector”.)

old ‘female’ connector new ‘female’ connector

Should you wish to convert more than one cable

system, the new female connector is available as

an accessory from most major DIY retail outlets

and from Black & Decker service centres (cat. no.

A6624S). If in doubt, consult a qualified electrician.

Existing powered garden tools

(UK only)

To connect existing Black & Decker garden power

tools to the new system you will require an adaptor

(see below). This is available as an accessory from

most major DIY retail outlets (cat. no. A6623S).

Warning! This adaptor is only suitable for

products rated up to 500W. It is not

recommended for use with the following:

Hover mowers, rotary mowers with grass

collection, chainsaws, shredders and blower

vacs. Please contact your local service

centre should you require further advice.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GT221 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,37 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker GT221 Manual

Product: