709565

Black Decker FSMH1300FX Manual

7
Zoom out
Zoom in
Previous page
1/8
Next page
6
ENGLISH
(Original instructions)
7
ENGLISH
(Original instructions)
u Use water only with no additives or chemicals with your
steam mop. To remove stubborn stains from vinyl or
linoleum oors, you can pre-treat with a mild detergent
and some water before using the steam mop.
Steam Cleaning with the mop
u Fit hand steam cleaner to the oor extension (8)
u Place a cleaning pad (10) on the oor with the velcro 'loop'
side facing up.
u Lightly press the steam mop down onto the cleaning pad
(10).
u Connect the steam mop to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Turn the Autoselect
TM
dial (2) until the required setting is
reached. After a few seconds steam will start to come out
of the steam head.
Note! When rst lled or after running dry, it can take up to 45
seconds for steam to be produced.
u It takes a few seconds for steam to enter the cleaning pad.
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
u Push and pull the steam mop slowly across the surface to
thoroughly steam clean each section.
u When you have nished using the steam mop, return
the handle (8) to the upright position, making sure that it
is supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately ve minutes).
Caution! It is important to monitor the water level in the water
tank. To rell the water tank and continue to sanitize/clean
stand the mop upright making sure that it is supported and
turn the steam mop 'OFF'. Unplug the unit from the electrical
wall outlet, and rell the water tank.
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
After use
u Turn the Autoselect
TM
dial (2) to the OFF position.
u Wait until the steam mop cools down.
u Unplug the steam mop from the electrical wall outlet.
u Empty the water tank.
u remove the cleaning pad (10) and wash it ready for next
use (take care to follow the wash care instructions printed
on the cleaning pad).
Accessories
The performance of your appliance depends on the accessory
used. BLACK+DECKER accessories are engineered to high
quality standards and designed to enhance the performance
of your appliance. By using these accessories you will get the
very best from your equipment.
Hand held steam cleaning
Warning! Only use in a horizontal position.
u Attach the required accessory.
u Connect the hand held steam cleaner to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Turn the Autoselect
TM
dial (2) until the required setting is
reached. After a few seconds steam will start to come out
of the steam head.
Note! When rst lled or after running dry, it can take up to 45
seconds for steam to be produced.
u When you have nished using the hand held steam
cleaner turn the Autoselect
TM
dial (2) to the OFF position.
Turn the unit OFF by pressing the ON/OFF button (1) and
disconnect from the mains supply. Wait until the unit cools
down before storing (approximately ve minutes).
Technical Data
FSMH1300FX
Voltage V
ac
230
Power W 1300
Tank
Capacity
ml 500
Weight kg 2.4
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem Step Possible solution
The steam mop is not
turning on
1. Check the unit is plugged in at the wall
socket.
2. Check the unit is switched on using the
ON/OFF switch (1)
3. Check the fuse in the plug.
The steam mop is not
producing steam
4. The steam mop will only produce steam if
the hand held steam cleaner (5) is
correctly docked into the main body (11)
or the steam hose is tted or the
Autoselect
TM
is turned to ON
5. Check that the water tank is full. Note:
When rst lled or after running dry it can
take up to 45 seconds for steam to be
produced.
6. Check steps 1, then 2, then 3
The steam mop stops
producing steam
during use
7. Check steps 4, then 5, then 3
The steam mop is
producing too much
steam during use
8. Turn the Autoselect
TM
dial (2)
anti-clockwise to reduce the amount of
steam being produced
The steam mop is
producing too little
steam during use
9. Turn the Autoselect
TM
dial (2) clockwise to
increase the amount of steam being
produced
Where can I get further
information/
accessories
10. www.blackanddecker.co.uk/steammop
www.blackanddecker.ie/steammop
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker FSMH1300FX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker FSMH1300FX in the language / languages: English as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info